Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
7. To Make A Diagonal Cut (Fig 10)
Diagonal cuts are also referred to as "long
point to long point cuts".
• Using a marker or grease pencil, mark the
area to be cut on material.
• Secure the workpiece.
• If wet cutting is desired, turn the water supply
valve to start water flow.
• Depress the switch trigger to start the saw.
• Let the cutting wheel build up to full speed
and wait for the wheel to get wet before
moving the wheel into the material.
• When the cut is made, release the switch
trigger. Wait for the cutting wheel to come to
a complete stop before removing the saw
from the material.
• Stop the water flow.
8. To Make A Miter Cut (Fig 11)
Miter cuts are used for cutting outside and inside corners with the material at any angle to the
wheel other than 90°. Miter cuts tend to "creep" during cutting. This can be controlled by
holding the workpiece securely against a straight edge guide.
• Using a marker or grease pencil, mark
the area to be cut on material.
• Secure the workpiece.
• If wet cutting is desired, turn the water
supply valve to start water flow.
• Depress the switch trigger to start the
saw.
• Let the cutting wheel build up to full
speed and wait for the wheel to get
wet before moving the wheel into the
material.
• When the cut is made, release the
switch trigger.
Wait for the cutting wheel to come to a
complete stop before removing
the saw from the material.
• Stop the water flow.
10
DIAGONAL CUT
11
MITER CUT
20
