Idiomas disponibles
Idiomas disponibles
washer. Insert and connect it quickly to prevent leakage. When the parts
are properly connected, the two components cannot be separated by
pulling directly on the water outlet. Press the "Button" according to
the direction of the arrow, then you can pull out the high pressure hose.
STEP 5
Connect the high pressure hose (6) to the gun (11). Insert and connect
it quickly to avoid leakage. When the parts are correctly connected, the
two components cannot be separated by pulling directly on the gun (11).
Press the gun lock button to remove the hose after use.
STEP 6
Connect the hose connector to the pressure washer. Before connecting
the connector to the male connector, remove the plastic cap that is
inserted into the male connector of the pressure washer prior to
shipment. This plastic cap can be discarded once removed. Once both
components are installed, connect the Garden Hose with the Connector
Screw to the Pressure Washer. Connect the garden hose to the water
inlet.
STEP 7
If connected to a non-pressurised water inlet, the water inlet must not
be more than 50cm below the water inlet of the machine.
Instruction manual
If the water source is at a higher elevation than the machine inlet, the
water surface must not exceed 50 cm to the top of the water container.
At this point, the sprinkler cannot be installed. After starting the
machine, wait for the water to flow from the gun head and then connect
the nozzle for use.
It is important to ensure that the elevation of the water source is
adequate before installing and using the sprayer, and to follow this
procedure to avoid operational problems.
INSTRUCTIONS
START-UP
After connecting the pressure washer to the cold water supply, proceed
as follows:
▶Make sure that the ON/OFF switch is in the OFF position.
▶Connect the garden hose to the inlet connector.
▶Insert the adjustable spray nozzle into the gun according to assembly
▶Connect the high pressure hose to the high pressure outlet connector
▶Connect the high pressure hose to the gun according to assembly
▶Connect the garden hose to the high pressure washer inlet connector
▶Fully open the water supply valve.
▶Before turning the unit on, press the gun trigger to bleed any
▶Turn the pressure washer on by turning the on/off switch to the on
21
step #3.
according to assembly step #4.
step #5.
according to assembly step no. 6.
remaining air from the pump and hose.
position and squeezing the trigger. Reminder: The motor does not run
continuously, only when the trigger is pulled.
ref. 08472
ES
PT
EN
FR
