Vaporesso XROS 4 Manual Del Usuario página 4

USE INSTRUCTIONS
1. Install & Replace the Pod
Pull out the pod from the battery and install the new one.
*If it's the first time using the device, please tear off the sticker of the
preinstalled pod.
2. Fill the E-liquid(Refer to FIGURE1)
Snap off the mouthpiece then squeeze the e-liquid through filling hole.
After filling, put the mouthpiece back and make sure it's shut firmly.
*If it's the first time filling the e-liquid, please wait 5 minutes for the coil to
prime.
3. Adjust Airflow(Refer to FIGURE2)
There is an airflow control toggle on the back of the battery. Adjust the
toggle according to your vaping habits for different airflow effects.
4. Power ON/OFF
Click the power button 5 times in 2 seconds to power on or power off the
device.
5. Start Vaping
The device is both button-activated and draw-activated. Press the power
button or inhale directly through the mouthpiece and exhale to start
vaping. The LED indicator will flash in green/blue/red color according to the
power status during vaping.
6. Check the Battery Level
The LED indicator will stay in green/blue/red color to show the battery level
after vaping or inserting the pod.
Battery Level
70%~100%
30%~70%
0~30%
7. Charging
Please use the in-box Type-C cable to charge the device. The LED Indicator
will display the color corresponding to the current battery level while
charging and stay in green while fully charged.
8.Lock Button
Click the power button 4 times in 2 seconds to lock the power button, and
the Power ON/OFF function still works.
9. Mode Settings
Click the power button 3 times in 2 seconds to enter the mode setting
interface, then click the power button to adjust the mode, wait 3 seconds to
save the current status and exit.
PROTECTIONS
Low Resistance/Short-circuit/High Temperature: The red indicator will flash
5 times and the device will stop working.
No Load/High Resistance: The current battery level indicator will flash 5
times and the device will stop working.
Low Voltage/Over Discharging: The red indicator will flash 3 times and the
device will stop working.
Over Charging: The green indicator will stay on and the device will stop
charging.
Overtimes(8s): The device will stop working and the LED indicator will flash
ENGLISH
LED Color
Green
Blue
Red
1