Idiomas disponibles
Idiomas disponibles
ELECTRIC OPERATION
CONTROLS
General controls
Assistance mode :
«1» mode is the default assistance mode when the screen is switched on.
1
The motor power adapts according to the selected mode
The motor power according to the modes is defined below:
Mode
% of electrical assistance contribution
Example for a user effort of 100 W, the total
power will be:
ON/OFF button:
2
Long press: Switch off electric-assisted bike.
Remote «+» button :
3
Navigating between the different assistance modes.
Press and hold down: Activation of walk mode. This mode allows you to push the bike and walk beside it at a maximum speed of 6 km/h.
Remote «-» button :
4
Short press : Navigating between the different assistance modes.
Long press: Activate the pairing mode
Settings / Information button :
5
Short press : Information selection
Long press: Settings menu
Battery level:
6
Battery status
Display «+» button :
7
Short press : Change view
Display «-» button :
8
Short press : Change view
Long press : Switch on/off the light
The electric bicycle can be used with or without assistance by pressing the ON/OFF button and playing around with modes 0-1-2-3-4. Assistance modes modes 0-1-2-3-4,
which you can select via the «D» screen, let you select a level of electrical assistance in addition to the effort you put in. The electrical assistance will only work if you pedal with
the screen switched on and if one of the 4 modes has been selected. Assistance cuts off when the speed is above 25km/h. During intensive use and in exceptional weather
conditions, the pedal-assist mode may cut out to safeguard the system. The power supplied is calculated by the controller inside the motor «C» according to your pedalling
rate and the force applied to the pedals. According to the mode selected, the controller «C» sends more or less current to the motor «C» to provide you with the desired level of
assistance. The pedaling power supplied by the user is calculated by a sensor located within the motor. The power supplied by the motor is equal to the user power multiplied
by a coefficient depending on the assistance mode.
The electrical assistance does not work or shuts down in the following situations:
• The speed is above 25km/h (+/-10%)
• You're not pedalling
• The remaining charge in the battery is not sufficient
• When the control screen is switched off or disconnected
• «0» is the power assistance mode selected
• When the control screen is switched off
• The electrical assistance may also cut out to protect the system in the event of
2
8
0
17:30
1
1
100
%
6
9
5
off
0%
+ 70%
100W
170W
10
.0
km/h
3
speed
trip
0
km
4
1
2
+ 150%
250W
intensive use and in exceptional weather conditions
• A cable is damaged.
• The battery is improperly inserted or in deep sleep.
3
4
+ 220%
+280%
320W
380W
