Idiomas disponibles
Idiomas disponibles
Motor Start Up
• Set the chain saw onto a leveled ground where the bar
and change make no contact with the ground or any
other object.
• Firmly hold the front handle with your left hand, set the
right foot onto the rear handle base (A).
• Push the chain brake toward the bar to check if the
chain is in the functioning position. (see page 8).
If the chain starts while the brake is
CAUTION
activated the chain saw may be seriously damaged.
• Set the switch into the ON position (B).
• Press completely and release the starter choke 10 times
(C).
• Pull the choke lever all the way out (D).
• Pull the jack-line (E) until the motor seems to start, but no
more than 5 times if the environment temperature is higher
than 50 °F. If the temperature is lower, pull the jack-line
(until the motor starts, but no more than 7 times.
• To fully engage the choke lever, press the switch lockout
and turn on the throttle.(F).
• Pull again the choke lever (E) until the motor starts.
• Once the motor starts leave it running 30 seconds in
that position.
• Pull the chain brake towards the auxiliary handle.
• Press and release the throttle trigger to run the motor
idle (G).
• The chainsaw is now ready to cut. Hold it by both
handles in the right position (see page 5) and lift it to start
working.
F
G
12
ENGLISH
Start Up
A
C
x10
B
D
E
