Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Inspection before start
• The power cord shall not be damaged or fractured.
• Please verify the rated current of the power socket is in line with the
requirements in the table above and is equipped with a safety grounding device before
use; otherwise, replace the socket.
Start and power selection
Start
• Press the "
" key in the standby state to enter the power-on state.
Power selection
• When the machine is running, press the "
switch in the cyclic sequence of "high-grade
[Note]
• To use the machine for the first time or to re-insert the socket, please pay attention to
check whether the plug and the socket are fitted well.
<Inspection method>
• Insert the power plug into the socket and start for use; after about half an hour, turn off
and pull out the plug. Check whether the plug pins are hot; replace the socket if so
(more than about 50°C) to avoid burning the plug or even causing a fire caused by
overheating of the socket due to poor contact.
Temperature adjustment
• In the power-on state, short press the "
press the key repeatedly to switch in the cyclic order of "18, 22, 26, 30, 35". Long press
the " " button, the temperature will increase continuously and rapidly (range 5-35°C).
If there is no key action within 5 seconds, confirm the
temperature setting value.
Stop
• Press the "
" key in the power-on state to enter the standby state.
Movement of the heater
• To move the heater, turn it off first, and pull out the power plug; then push the body to
make the four casters below the body to roll.
" key repeatedly, and the machine will
mid-grade
" key to enter the temperature setting state,
5
low-grade
high-grade".
