Idiomas disponibles
Idiomas disponibles
Operate the Aeromat exclusively through the sealed spray can intended for this Aeromat.
Otherwise, the medium can be sprayed in an uncontrolled manner, which can lead to
injuries to the eyes and respiratory tract!
FILLING THE SPRAY BOTTLE:
Place the spray bottle intended for this Aeromat on the material/air extraction point.
process by pressing the spray bottle down evenly.
Only relieve the pressure on the spray bottle when the filling process is
compressed air has
flowed in.
process takes approx. 12 sec. Additional filling of compressed air via the black air extraction point is
not necessary afterwards. The spray bottle is already ready for use.
If you have interrupted the filling process by mistake, do not press the spray bottle onto the coloured
extraction point again, but simply fill the spray bottle with compressed air at the black air extraction
point. Filling again at the coloured extraction point would result in more than 400 ml of medium being
filled and would thus disturb the relationship between medium and compressed air.
Please note: All further filling must be done when the spray bottle is empty. Please process residual
material beforehand and then allow the residual air in the spray bottle to escape. This can be achieved
by releasing the spray valve or by slightly unscrewing the union nut.
Only when the spray bottle is completely empty (medium E
compressed air) will the optimum filling ratio be produced when
the spray bottle is refilled.
If the compressed air has escaped prematurely due to unintentional opening of the spray can, but there
is still medium in the spray bottle, it must be refilled at the black air extraction station. If desired, the
pressure in the spray bottle can be reduced at any time using the black air extraction station.
air extraction point to the original pressure. As a rule, filling according to the described instruction is
sufficient to empty the medium with the existing compressed air volume.
WORKING END:
Keep the valves of the tapping points free of dirt and the centre-mounted seal of the tapping point lightly
greased. If the Aeromat is used frequently, leave them fully
ensure that the Aeromat is in "standby" mode
and can be operated at any time. If the Aeromat is not used for a longer period of time, we recommend
disconnecting it from the compressed air supply and emptying the spray bottles.
This is the case when no more filling can be heard or felt. A filling
4
completed
connected to
the
compressed air network. To
EN
Start the filling
after the
