Idiomas disponibles
Idiomas disponibles
Troubleshooting guide
Cause
Problem
• Sw i t c h i n g o n t h e
Button
blinking
appliance or starting
+
Indicator light solid blue
an automatic cooking
+ Button
blinking
c y c l e
and without plates
preheating (manual
mode is automatically
activated).
The appliance stops during the cycle of
• The appliance has been
pre-heating or cooking.
kept open for too long
while cooking.
• The appliance has been
idle too long after the
end of warm up or keep
warm.
• Appliance failure.
The indicator light will blink purple
• Appliance stored or used
+ Button
/
/
/
blinking
in a room that is too cold.
+ Intermittent beeping
The device does not beep.
• Appliance failure.
The indicator light will blink purple
+ Button
blinking
+ Continuous beeping
After preheating, I placed the food inside
• The quantity of food
and closed the appliance,
but the
inside the appliance is
indicator light stays white and cooking
greater than 4 cm.
does not begin.
• The grill was not opened
completely when placing
the food inside.
• The appliance does not
detect food inside The
quantity of food is
insufficient, " OK " is
blinking.
The appliance will activate in manual mode
• Preheating time was cut
short.
+
The indicator light will blink red.
+ button
temp control and
light
fixed
16
Solution
• 2 possible options:
– Choose the temperature setting by
pressing the
button and then
w i t h
f o o d
press OK. Allow to cook, but you must
monitor the cooking (manual mode).
– stop the appliance, remove the
food, close the appliance properly,
re-program the appliance and wait
until end of preheating.
• Disconnect the appliance from the
outlet and leave for 2-3 mins., restart
the process. The next time you use the
appliance, make sure you open and
close it quick for best cooking results. If
the problem occurs again contact your
local Tefal customer service.
• Disconnect and reconnect your
appliance and immediately restart a
preheat cycle. If the problem persists,
contact your Customer Service.
• Unplug the appliance and contact
customer service.
• The quantity of food should not exceed
4 cm.
• Open the grill completely and close it
again.
• Confirm cooking activation by pressing
the button
.
• Monitor the cooking periodically
(for use in manual mode).
Or
• Stop the grill, remove food, close the grill,
select the new cooking programme you
wish to use and wait for the preheating
cycle to finish.
TABLE DES MATIÈRES
• Description du produit
• Positions et interfaces
• Indicateur du niveau de cuisson
• Avant la première utilisation
• 1. Position grill
a) Utilisation d'un programme automatique
b) Utilisation du mode manuel
c) Guide de cuisson
• 2. Position barbecue
• Fin de cuisson
• Nettoyage
• Guide de dépannage
18
19
20
21
22
22
25
26
27
28
29
30
17
