Idiomas disponibles
Idiomas disponibles
16. Line/Mic Input Selector
Press this button for switch between line input and
microphone signal.
Button pressed: Microphone signal.
Button not pressed: Line input signal.
17. XLR Input
Balanced XLR input for connecting microphone or line
signal.
18. RCA/Jack Input
RCA and 3.5mm jack input for connecting audio units with
line level output (e.g. mixer, CD player, tape recorder).
19. Monitor Output
RCA connector with master signal, used for monitoring or
record.
20. Power switch
Turn the power on/off
21. Power input
Before connecting the power cord, check if the mains
corresponds to the voltage indicated on the rating plate on
the unit.
22. Voltage switch
Select the correct
23. Fan
Cooling of the amplifier. Do not cover or obstruct the fan hole.
CONNECTING WITH BT-DEVICE
1.
2.
3.
If password is required, you can enter "0000".
Attention: The BT distance is approx. 10 meter without any barrier.
REPLACING THE FUSE
If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
the input voltage to the power supply to either 110/115Volt or 220/230Volt.
Activate the BT-function on your device (Mobile phone, tablet etc.) which you want to play the music.
See the operating instructions for that device.
Press the "MODE" button and activate BT-function of soundbox.
Select "
" on your BT-device and make the BT-connection
Power Dynamics
5
