Power Dynamics PD910 Manual De Instrucciones página 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
CONTROLS AND CONNECTIONS
1. Channel Volume
Adjust the level of the channel signal to the master
signal.
2. Effect Volume
Adjust effect input signal level
3. Bass
Adjust high low tone control from output signal.
4. Treble
Adjust high tone control from output signal.
5. Clip Indicator
The LED lights up when the input signal is driven
too high. If this happens, reduce the channel signal.
6. Channel 3/4 Volume
Adjust the level of audio units with line level output
(e.g. mixer, CD player, tape recorder) to the master
signal.
7. Bluetooth volume
Adjust the level of the Bluetooth signal.
8. Bluetooth pairing button
Press this button for 1 second to pair your Bluetooth device. Press this button for 1 second again to disconnect with
your Bluetooth device.
9. Channel 5/6 Volume
Adjust the level of the line input or 3.5mm jack input to the master signal.
10. DSP Effect
Turn the button for select the digital sound processor effect.
11. Effect to master
Adjust digital sound processor effects signal level to the master signal.
1. Hall 1
2. Hall 2
3. Room 1
4. Room 2
5. Reverb-delay
6. 125ms Delay
7. 175ms Delay
8. 225ms Delay
12. Monitor volume
Adjust the level monitor output signal.
13. Master Volume
Adjust the overall output level of the sound system.
14. LED Indicator
Power: The blue LED lights up when console in powered on.
Limit: The LED lights up when the input signal is driven too high. If this happens, reduce the master signal.
Level Indicator: Displays the signal of output in 5 segments.
15. DSP Mode
Press this button to select one of pre-programmed digital sound processor effects (Live, Voice, Monitoring or Rock).
9. 285ms Delay
10. 560ms Delay
11. 860ms Delay
12. 1000ms Delay
13. 1400ms Delay
14. 800ms PingPong Delay
15. 1000ms PingPong Delay
16. 1400ms PingPong Delay
4