Idiomas disponibles
Idiomas disponibles
For OUTDOOR use only. DO NOT use in a building, garage, or any other enclosed area. DO NOT use in or on
recreational vehicles or boats. NEVER use this appliance as a heater.
DO NOT operate appliances under ANY overhead construction. Keep a minimum clearance of 10 feet (3 m) from the
sides, front and back of appliance to ANY construction. Keep the area clear of all combustible material and flammable
liquids, including wood, dry plants and grass, brush, paper, and canvas.
Use ONLY on a level, stable non-combustible surface like bricks, concrete, or dirt. DO NOT use this appliance on any
surface that will burn or melt like wood, asphalt, vinyl, or plastic.
Keep the fuel supply hose away from any heated surfaces.
To prevent accidental fires, before using the appliance ensure that the hose is not damaged and all joints and
connections are not leaking by turning on the cylinder valve, leaving the burner valve closed, and applying a soapy
solution to the joints and connections. If a continuous hissing sound is heard, or if the soapy solution bubbles, there is
a leak. DO NOT use the appliance if there is a leak. Replace the faulty parts.
Extinguish all open flames before connecting the gas supply to the appliance and before checking for leaks.
Use appliance only with LP (propane) gas and the regulator/valve assembly supplied. Installation must conform with
local codes, or in their absence with National Fuel Gas Code, NFPA 54/ANSI Z223.1. Handling and storage of LP
cylinders must conform to LP Gas Code NFPA/ANSI 58. Appliance is not for use in or on recreational vehicles and/or
boats.
Before opening LP tank valve, check the coupling nut for tightness. When appliance is not in use, turn off control knob
and LP tank valve on supply cylinder.
NEVER use LP tank if visibly rusted, damaged, or out of date.
If you notice grease or other hot material dripping from appliance onto valve, hose or regulator, turn off gas supply at
once. Determine the cause, correct, clean and inspect valve, hose and regulator before continuing. Perform a leak
test.
Clean and inspect the hose before each use of the appliance. If there is evidence of abrasion, wear, cuts or leaks, the
hose must be replaced prior to the appliance being put into operation. See product sheet for hose & regulator
information.
DO NOT block hoses in bottom or sides of appliance.
ALWAYS close LP tank valve and remove coupling nut before moving LP tank from specified operating position.
NEVER store a spare LP tank under or near appliance or in enclosed areas. NEVER fill the cylinder beyond 80% full.
An overfilled spare LP tank is hazardous due to possible gas released from the safety relief valve. Failure to follow
these instructions exactly could cause a fire resulting in death or serious injury.
If you see, smell, or hear escaping gas, immediately get away from the LP tank/appliance and call your fire
department.
Combustion by-products produce when using this product contain chemicals known to the State of California to cause
cancer, birth defects, or other reproductive harm.
Turn OFF all control knobs and LP tank valve. Turn coupling nut counterclockwise by hand only - DO NOT use tools to
disconnect. Install safety cap onto LP tank valve. ALWAYS use cap and strap supplied with valve. Failure to use safety
cap as directed may result in serious personal injury and/or property.
A disconnected LP tank in storage or being transported must have a safety cap installed(as shown). DO NOT store an
LP tank in enclosed spaces such as a carport garage, porch, covered patio or other building. NEVER leave an LP tank
inside a vehicle, which may become overheated by the sun.
IMPORTANT SAFETY INFORMATION
2
