Daitsu ADDH-10 Manual De Usuario página 22

Problem Possible Causes
Dehumidifi er The humidifi er is umplugged • Make sure the dehumidifi er's plug is pushed
does not start
Dehumidifi er has reached its
preset level or bucket is full.
Bucket is not in the proper
position.
Power failure.
Dehumidifi er does Did not allow enough time to
not dry the air as it remove the moisture.
should
Airfl ow is restricted.
Dirty fi lter.
The Humidity Control may
not be set low enough.
Doors and windows may not
be closed tightly.
Clothes dryer may be
blowing moisture-laden air
into the room.
Room temperature is too
low.
Dehumidifi er runs Area to be dehumidifi ed is
too much too large.
Doors and windows are
open.
Frost appears on Dehumidifi er has been
the coils recently turned on, or room
temperature is below 5°C.
Controls cannot The compressor will turn off
be set and the fan will automatically
continue to run for
approximately 3 minutes at a
fi xed setting.
Fan noise There is sound created
when wind passing the unit.
That is the sound of wind.
Water on fl oor Hose connection may be
loose.
Intend to use the bucket to
collect water, but a hose is
attached.
What To Do
completely into the outlet.
• The dehumidifi er automatically turns off when either
condition occurs. Change to a lower setting or empty
the bucket and replace properly.
• The bucket must be in place and securely seated for
the dehumidifi er to operate.
• There is a protective time delay (up to 3 minutes) to
prevent tripping of the compressor overload. For this
reason, the unit may not start normal dehumidifying for
3 minutes after it is turned back on.
• When fi rst installed, allow at least 24 hours to
maintain the desired dryness.
• Make sure there are no curtains, blinds or furniture
blocking the front or back of the dehumidifi er. See the
Choosing a Location section.
• See the Care and Cleaning section.
• For drier air, press the " - " pad and set to a lower
percent value (%) or at CO (continuous) for maximum
dehumidifi cation.
• Check all doors, windows and other openings are
securely closed.
• Install the dehumidifi er away from the dryer.
The dryer should be vented to the outside.
• Moisture removal is best at higher room
temperatures. Lower room temperatures will reduce
the moisture removal rate. Models are designed to be
operated at temperatures above 5°C.
• The capacity of your dehumidifi er may not be
adequate.
• Close all doors and windows to the outside.
• This is normal. Frost will usually disappear within 60
minutes. See the Automatic Defrost section.
• This is normal. Wait approximately 3 minutes and set
the fan as desired.
• This is normal.
•Check the hose connection. See the Removing
Collected Water section.
• Disconnect the hose if using the bucket to collect
water. See the Removing Collected Water section.
22