Tabla de contenido
Idiomas disponibles
Idiomas disponibles
How to Use | Cleaning
WARMING A SECOND BOTTLE
The appliance is equipped with a safety feature, designed to prevent bottle contents from
overheating, that will not allow an additional warming cycle to begin until the unit has cooled
to a safe operating temperature.
If you wish to warm a second bottle immediately after warming the first one, there are two options:
Option 1: With the appliance OFF and the hot water still in the warming chamber, place the
second bottle into the chamber using the basket. Keep the bottle in the appliance for the
same duration as the first bottle (refer to WARMING TIMES chart).
Option 2: Pour the hot water out of the warming chamber and fill it with cold water, allowing
2-3 minutes for the appliance to cool down. Then pour the water out and restart the warming
process, starting from step 1.
ADDITIONAL NOTES
To switch to a different mode after warming has already started, turn the control dial to select
the new mode. The appliance will override the current mode and adjust the warming time.
If you switch from a higher warming mode to a lower one and the target warming time has
already been exceeded, the unit will beep twice and shut off. Always check the temperature
of the bottle's contents before feeding.
TO CLEAN
Always unplug the appliance and allow it to cool before cleaning. Do not use scouring pads,
abrasives or solvents. Do not submerge the unit in water.
Main unit: Clean with white vinegar and wipe with a damp cloth.
Lift-out basket: Wash with warm soapy water. Top-rack dishwasher safe.
10
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and complies with the specifications for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used according to the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
is found by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult Munchkin, Inc. or a qualified technician for help.
This Class [B] digital apparatus complies with Canadian CAN ICES-3 (B)/NMB-3(B).
FCC Statement
11
Tabla de contenido
