Mounting The Camera; Tools Required - Waeco mobitronic RV-24 Instrucciones De Montaje Y De Servicio

Camara de video de marcha atras
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 55
_RV-24_RV-27.book Seite 31 Dienstag, 18. Mai 2004 11:25 11
RV-24, RV-27
Attach the cables securely in the vehicles to prevent tripping hazards.
Use cable binders, insulating tape or glue the cables in place.
Protect every through-hole made in the bodywork against water penetration,
e.g. by using a cable with a sealant and by spraying the cable and the the
cable sleeve with sealant.
Do not start sealing the through-holes until all installation work
has been finished for the camera, and the required cable lengths
have been established.
8

Mounting the camera

8.1

Tools required

For installation and assembly you will require the following tools:
Drill bit set (see 1 1, page 3)
Drill (see 1 2, page 3)
Screwdriver (see 1 3, page 3)
Set of ring or open-ended spanners (see 1 4, page 3)
Measuring ruler (see 1 5, page 3)
Hammer (see 1 6, page 3)
Centre punch (see 1 7, page 3)
To make and test the electrical connection, the following tools are required:
Diode test lamp (see 1 8, page 3) or voltmeter (see 1 9, page 3)
Insulating tape (see 1 11, page 3)
Cable bushing sleeves, if necessary
To fasten the cables you may require additional cable binders.
Mounting the camera
31
Tabla de contenido
loading

Este manual también es adecuado para:

Mobitronic rv-27

Tabla de contenido