Idiomas disponibles
Idiomas disponibles
Tape
"_
Wiring harness
5.
Raise seat and tighten
bolt securely.
6.
Remove
tape and discard.
7.
Lower
seat
into operating
position
and
sit on seat.
Press
brake
pedal
all the
way
down.
If operating
position
is not
comfortable,
adjust
seat.
Slot
Tape
Pad
Flat
washer
TO ASSEMBLY
BAGGER
1.
Unfold
bag and stand
right side up.
2.
Feed front bagger
frame
(1) up through
fabric
loops
at each
side of bagger.
3.
Snap bottom offrontbaggerframe
(1)into
snap feature
at front of bagger
bottom.
4.
Slidebaggerfabricloop(2)
segmentsatthe
ends of bag onto top bagger frame tubing.
5.
Uninstall
two (1\4"-20
x 1.15") hex bolts
(3) from the front of top frame.
6.
Reinstall
the two
(1\4"-20
x 1.15")
hex
bolts (3) through
holes at top of the front
bagger
frame and thread
into nuts inside
the tubing
of top bagger
frame.
Seat
pan
Adjustment
Bolt
Tab
handle
TO ADJUST
SEAT
Grasp
adjustment
handle
and pull up, slide
seat to desired
position
and release
adjust-
ment handle.
NOTE:
You may
now
roll your
tractor
off
the
skid.
Follow
the
instructions
below
to
remove
the tractor
from the skid.
WARNING:
Before
starting,
read,
un-
derstand
and follow
all instructions
in the
Operation
section
of this manual.
Be sure
tractor
is in a well-ventilated
area.
Be sure
the area in front of tractor
is clear
of other
people
and objects.
TO
ROLL
TRACTOR
OFF
SKID
(See
Operation
section
for
location
and
function
of
controls)
1.
Raise attachment
lift lever to its highest
position,
2.
Release
parking
brake
by depressing
clutch/brake
pedal,
3.
Place gearshift
lever in neutral
position.
4.
Roll tractor
forward
off skid,
5.
Remove
banding
holding
the deflector
shield
up against
tractor,
Continue
with the instructions
that follow.
7.
Uninstall
(1/4"-20)lock
nuts (4) atbottom
of front bagger
frame.
8.
Unfold
cross
braces
(5) and
attach
to
carriage
bolts at bottom
corners
of front
bagger
frame.
9.
Reinstall
(1/4"-20)
lock
nuts
(4)
and
tighten
until fully seated.
10. Remove
clevis pin (6) and retainer
spnng
(7) from bagger
handle
(8).
11. Slide bagger handle (8) down through
bag-
gercoverandframeupperweldmentholes.
12. Reinstall
clevis
pin
(6) through
hole
at bottom
of bagger
handle
and slide
retainer
spring
(7) into hole at the end
of the clevis
pin until it locks
into place
