Idiomas disponibles
Idiomas disponibles
TO REPLACE
MOWER
BLADE
DRIVE BELT
The mower blade drive belt may be replaced
without
tools.
Park the tractor
on level sur-
face.
Engage
parking
brake.
BELT REMOVAL-
1. Remove
mower.
(See "TO REMOVE
MOWER" in this section of manual.)
2. Work belt off mandrel
pulley and idler
pulleys,
3. Pull belt away from mower.
BELT
INSTALLATION-
1.
Work
belt
around
mandrel
pulley
and
idler pulleys
2.
Make
sure
belt
is in all pulley
grooves
and inside
all belt guides.
3.
Install
mower
(See "To Install
Mower"
in
this section
of this manual).
Mandrel
Pull_
Idler
;Pulleys
TO REPLACE
MOTION
DRIVE
BELT
Park the tractor
on level surface.
Engage
parking
brake.
For assistance,
there
is
a belt installation
guide
decal
on bottom
side of left footrest.
BELT REMOVAL
-
1.
Remove
mower
(See "TO REMOVE
MOWER"
in this section
of manual).
NOTE:
Observe
entire
motion
drive
belt
and position
of all belt guides
and keepers.
2.
Remove
belt from stationary
idler (A)
and clutching
idler (B).
3.
Pull belt slack
toward
rear of tractor.
Remove
belt upwards
from transaxle
input pulley
(D).
4.
Remove
belt downward
from engine
pulley
(E).
5.
Slide
belt toward
rear of tractor,
off the
steering plate (F) and remove from tractor.
TO CHECK
BRAKE
If tractor
requires
more than five (5) feet to
stop at highest
speed
in highest
gear on a
level,
dry concrete
or paved
surface,
then
brake
must
be serviced.
You may also check
brake
by:
1.
Park tractor
on a level,
dry concrete
or
paved
surface,
depress
brake
pedal
all
the way down and engage
parking
brake.
2.
Disengage
transmission
by
placing
freewheel
control
in "transmission
disen-
gaged"
position.
Pull freewheel
control
out and into the slot and release
so it is
held in the disengaged
position.
The rear wheels
must
lock and skid when
you try to manually
push the tractor
forward.
If the
rear
wheels
rotate,
then
the
brake
needs
to be serviced.
Contact
a Sears
or
other
qualified
service
center.
BELT INSTALLATION
-
1.
Install
new belt from tractor
rear to
front,
over the steering
plate
(F) and
above
clutch
brake
pedal shaft
(G).
2.
Pull belt toward
front of tractor
and roll
belt onto engine
pulley
(E).
3.
Pull belt toward
rear of tractor.
Care-
fully work
belt down
around
transaxle
input pulley
(D). Be sure belt is inside
the belt keeper.
4.
Install
belt through
stationary
idler (A)
and clutching
idler (B).
5.
Make sure
belt is in all pulley
grooves
and inside
all belt guides
and keepers.
6.
Install
mower
(See "TO INSTALL
MOWER"
in this section
of manual).
24
