Idiomas disponibles
Idiomas disponibles
5.2 Use
EN
WARNING
The installation of the device and maintenance should only be carried out by professionals.
• Do not leave the device running without monitoring it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
Manual :
- The device must be completely removed from its packaging. All protection must be completely removed.
- Place the appliance upright on a solid, flat surface. Never place the refrigerated display case on a
flammable surface. Place this machine to ensure optimal air circulation. We advise you to keep a minimum
distance of 10 cm from the wall and other objects.
- Do not install this device near open fires or other heating devices.
- Do not install the device in a wet or humid place.
- The electrical cable must be protected at least 16 amps. The device must be plugged directly into a wall
outlet. Using a power strip will cause the device to trip.
- To avoid damage to the compressor, the device must not be tilted
more than 45° during transport or installation.
- Leave the device to rest for 2 hours before its first use.
Digital temperature regulator:
1. Adjust the temperature: Press the button
, the set temperature is displayed. Push the button
Or
to modify and store the displayed value. Push the button
to exit the setting and display the cold room
temperature.
2. If you do not press any other button within 10 seconds, the cold room temperature will be displayed.
3. Lighting: Press the button
, it lights up; press again, it stops.
Manual defrost with stop/start:
Push the button
and hold it for 6 seconds to defrost or stop defrosting.
4. Refrigeration LED: During refrigeration, the indicator light is on; When the cold room temperature is
constant, the indicator light is off; During delayed start, the indicator flashes.
5. Defrost LED: During defrosting, the LED is on; When defrosting stops, the LED is off. During the defrost
delay display, the LED flashes.
WARNING !
The compressor may reach a high temperature. It is prohibited to touch the surface of the
compressor when the device is running or immediately after use to avoid any risk of injury!
