Safety Instructions - HQ-Power PROMIX22U Manual Del Usuario

PROMIX22U – PROFESSIONAL MIXER - 5 CHANNELS - USB IN/OUT
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPOWER! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.

2. Safety Instructions

Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
• Do not expose the device to liquids and make sure not to place any object containing liquid on top of the device.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
3. Description
a. Mono Input
1. MIC Input
Each mono input channel offers a balanced microphone input via the XLR
connector and also features a switchable +48V phantom power supply for
condenser microphones. The XLR jack is configured for pin 1 (ground), pin 2
(positive (+)) and pin 3 (negative (-)).
2. LINE Input
The LINE input is designed to accept balanced or unbalanced line level
signals such as those from keyboards, drum machines or samplers. There is
enough gain available on the line input to accept even lower level signals such
as those from an unbalanced microphone or guitar output. If a balanced signal
is to be connected to the line input, then a ¼" TRS (stereo) phone plug should
be wired for the tip (positive (+)), the ring (negative (-)) and the sleeve
(ground).
PROMIX22U_v2
3 HQPOWER