Idiomas disponibles
Idiomas disponibles
3. Lighting: Press the button
Manual defrost with stop/start:
Push the button
and hold it for 6 seconds to defrost or stop defrosting.
4. Refrigeration LED: During refrigeration, the indicator light is on; When the cold room temperature is
constant, the indicator light is off; During delayed start, the indicator flashes.
5. Defrost LED: During defrosting, the LED is on; When defrosting stops, the LED is off. During the defrost
delay display, the LED flashes.
6. Resetting the digital controller
When the screen shows "disorder", press the button for 2 seconds until the beep sounds, quickly press the
button for 6 seconds until the beep sounds again, the screen flashes for 3 seconds and restores factory
settings.
5. INSTALLATION AND USE
5.1 Safety instructions
ELECTRICAL DANGER
Risk linked to electric current!
• No contact with heat sources should take place with the electrical cord.
• The cord should not hang over the edge of a table or counter.
• Do not pour water into a device that is operating or still hot.
• The device must be properly connected and comply with current regulations.
WARNING
When operating, the device can reach high temperatures. To avoid burns and accidents, do not use the
device if it is malfunctioning, and do not use spare parts that are not original.
ELECTRICAL DANGER
Risk linked to electric current!
If incorrectly installed, the device may be dangerous and cause injury. Before any installation, check the
electrical network data. Plug in the device only when it complies. The device must be unpacked and checked
completely before connection by a professional.
5.2 Use
WARNING
The installation of the device and maintenance should only be carried out by professionals.
• Do not leave the device running without monitoring it.
• During use, your hands must be dry.
• Do not move or tilt the device during operation.
Manual :
- The device must be completely removed from its packaging. All protection must be completely removed.
- Place the appliance upright on a solid, flat surface. Never place the refrigerated display case on a flammable
surface. Place this machine to ensure optimal air circulation. We advise you to keep a minimum distance of
10 cm from the wall and other objects.
- Do not install this device near open fires or other heating devices.
- Do not install the device in a wet or humid place.
- The electrical cable must be protected at least 16 amps. The device must be plugged directly into a wall
outlet. Using a power strip will cause the device to trip.
- To avoid damage to the compressor, the device must not be tilted
more than 45° during transport or installation.
- Leave the device to rest for 2 hours before its first use.
- Before use, the device must be cleaned
, it lights up; press again, it stops.
EN
