Idiomas disponibles
Idiomas disponibles
Trimming
1 Press the length selector and then slide it
up or down to select the desired hair length
setting (Fig. 6).
2 Press the trimmer head on/off button to
switch on the product (Fig. 7).
3 Trim against the direction of hair growth
for optimal performance (Fig. 8).
Note: Make sure that the flat part of the
trimming guard is always fully in contact
with the skin.
4 Switch off and clean the product after each
use.
Shaving
Do not use the shaver head to shave or trim
hair on the face or head.
- When shaving sensitive areas for the first
time, you may feel some discomfort,
irritation or reddening of the skin. This is
normal as your skin needs time to adjust to
shaving.
- If your hair is longer than 13/32 in. (10
mm), trim hair to a length of 1/8 in. (3 mm)
first for optimum shaving results.
- For dry use, be certain that your skin is
clean and dry before using the shaver head.
Inspect the shaving foil of the shaver head
before each use. Replace the shaving foil head
when the foil is damaged (Fig. 9).
1 Press the shaver head on/off button to
switch on the product (Fig. 10).
2 Stretch your skin taut with your free hand
(Fig. 11). Gently press the shaver head to
skin and move it slowly and smoothly
against the direction of hair growth (Fig.
12).
- Do not press too hard. Too much pressure
can distort the foil and cause skin irritation.
- Make sure the shaver head is always in full
contact with your skin.
- The shaver is bi-directional, which means
that you can shave by moving the product
up and down. Shave against the direction
of hair growth for optimal performance.
3 Switch off and clean the product after each
use.
Cleaning
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as
gasoline or acetone to clean the product.
Never dry trimmer or shaving foil head
with a towel, brush or tissue, as this may
cause damage.
Cleaning the trimmer head
1 Switch off the product.
2 Remove the guard by pressing the length
selector and sliding it upwards (Fig. 13).
Rinse the guard with water.
3 Open the cutting element by pressing the
cutting element upwards with your thumb
(Fig. 14).
4 Clean the hair chamber with the brush and
rinse it under the tap (Fig. 15).
5 Shake off excess water. Allow the product
to air-dry completely.
6 Close the trimming unit. You will hear a
click (Fig. 16).
7 Reattach the trimming guard and press the
length selector button to lock it in the right
position (Fig. 17).
Cleaning the shaver
1 Switch off the product.
2 Pull the shaving foil unit out of the shaver
head (Fig. 18).
Hold the shaving foil unit by the plastic
housing only.
3 Rinse the shaving foil unit with lukewarm
running tap water. Shake off excess water
(Fig. 19).
4 Allow the shaving foil unit to air-dry
completely.
5 Rinse the hair chamber with lukewarm
running tap water to remove any residual
debris (Fig. 20).
6 Reattach the shaving foil unit by snapping
it back into the shaver head. You will hear a
click (Fig. 21).
