Urmet GALET4-UP Manual Del Usuario página 7

GALET4-UP 4820393 Table-mounted 4-channel remote control
TLC1-UP 4820394 1-channel key fob remote control
TLC2-UP 4820395 2-channel key fob remote control
TLC4-UP 4820396 4-channel key fob remote control
TLC8-UP 4820397 8-channel key fob remote control
TLM1-UP 4820398 1-channel wall-mounted transmitter
TLM2-UP 4820399 2-channel wall-mounted transmitter
TLM4-UP 4820400 4-channel wall-mounted transmitter
TLM1T503-UP 4820401 Wall-mounted transmitter for 503 1-channel boxes
TLM2T503-UP 4820402 Wall-mounted transmitter for 503 2-channel boxes
TLM4T503-UP 4820403 4-channel wall-mounted transmitter for 503 boxes
All UP receivers are compatible with UP transmitters
(remote controls, wall-mounted remote controls, flush-mounted transmitters).
Functions and configurations
WARNING!
To configure a transmitter, you must first access the Configuration Menu:
Make 10 short presses on a remote control button (or press and hold 2 buttons simultaneously).
►The transmitter LED will start flashing quickly.
While the LED is flashing, push for the number of times (N) corresponding to the desired configuration
on the key to be programmed.
If the module is controlled by a remote control and the latter only has this module associated with a button - in standard mode (code 1), it is possible
to configure the module from the remote control without having access to the module's local button.
Case of the dimmer MTV300 :
a press on the transmitter button switches the light on/off; holding the button down causes the change.
Presses
short (No.
Functions
of times)
Switching on/off or up/down (depending
1
on the module controlled)
3 Switching on or up
4 Switching off or down
Presses
short (No.
Layouts
of times)
15 Key/channel reset
22 Using an E2BP in switch mode
Reset of transmitter factory settings and
25
cancellation of network connection
Use of transmitters with an NC or NO
33
device (switch between modes)
7/21
ZigBee remote controls / transmitters
Response (no.
of flashes)
1
3
4
Response (no.
of flashes)
5
2
1
3
Presses
short (No.
Using the key/channel
of times)
10 Use for lighting
11 Use to control openings
Mixed use for lights and openings
xN
20
(factory setting)
Presses
short (No.
Command modes
of times)
5 Direct mode (maximum 8 receivers)
Transmission command / centralised or
6
xN grouped control
Access the product page
for further information.
250m in free air space or inside a 100m²
house with perpendicular crossing of a main
wall or slab.
EN
Response (no.
of flashes)
10
1
10
Response (no.
of flashes)
5
6