WARNING:
1. THESE PUMPS ARE APPROVED FOR USE WITH WATER ONLY.
2. DO NOT USE THESE PUMPS IN OILY OR VERY DUSTY ENVIRONMENTS.
3. SIZE PUMP TO HANDLE MAXIMUM CONDENSATE FLOW UNDER
WORST CASE CONDITIONS.
4. CHECK THAT PUMP VOLTAGE MATCHES EVAPORATOR VOLTAGE
BEFORE STARTING INSTALLATION.
5. INSTALL, PIPE AND WIRE STRICTLY IN ACCORDANCE WITH
MANUFACTURERS INSTRUCTIONS.
DO NOT USE DISCHARGE HOSE LARGER THAN 1/4" i.d.
6. DO NOT OPERATE PUMP WITHOUT FILTER.
7. DO NOT RUN PUMP DRY, SERIOUS DAMAGE WILL OCCUR AND
INVALIDATE WARRANTY.
8. INSPECT PUMP REGULARLY, CLEAN RESERVOIR AND FILTER AND
ENSURE THAT FLOAT OPERATES FREELY AT ALL TIMES.
9. CAUTION: DO NOT OPERATE THIS PUMP WHEN ANY UNAPPROVED
CLEANING CHEMICALS ARE PRESENT IN THE CONDENSATE DRAINAGE
SYSTEM. OPERATING THE PUMP WHEN UNAPPROVED CLEANING
CHEMICALS ARE PRESENT WILL RESULT IN PERMANENT
DAMAGE TO PUMP AND VOID WARRANTY.
10. AFTER INITIAL INSTALLATION AND/OR MAINTENANCE,DO NOT LEAVE
SITE UNTIL PUMP HAS BEEN TESTED FOR CORRECT OPERATION.
11. ANY DEBRIS FROM MANUFACTURING AND/OR PACKAGING AS WELL
AS ANY ENVIRONMENTAL OR CONSTRUCTION DEBRIS FROM
BUILDING OPERATIONS WILL DAMAGE PUMP PERMANENTLY AND
THESE MUST BE FLUSHED FROM EVAPORATOR COIL AND DRAIN PAN
PRIOR TO INITIAL ACTIVATION OF PUMP.
12. ENSURE ANTI SIPHON DEVICE IS CORRECTLY INSTALLED WHEN REQUIRED.
13. ENSURE THAT NOTES PERTAINING TO NOISE DETAILED ON PAGE 3, HAVE
BEEN TAKEN INTO CONSIDERATION BEFORE INSTALLING PUMP.
In terms of section 307.2.3 the new building codes mandate the installation of an overflow switch on
all Minisplit Airconditioners
NOTE: That The integral overflow switch on any condensate pump cannot be used for this purpose
as, if the blockage is in the drain pan outlet or in the drain hose, or, if the filter gets blocked, the
condensate will never be able to reach the reservoir to activate the overflow switch in the pump.
Therefore a separate independent overflow switch is required to provide the maximum level of
overflow protection as well as to bring the installation into conformance with the code.
Even though this code may not yet be currently enforced in all areas,
IT IS HIGHLY RECOMMENDED THAT A SEPARATE OVERFLOW SWITCH IS INSTALLED ON ALL MINISPLIT
EVAPORATORS, INCLUDING THOSE WITH FACTORY FITTED OR AFTERMARKET PUMPS.
Refer to Model SS 610 E on Rectorseal website.
16
