Idiomas disponibles
Idiomas disponibles
In order to access the reader connectors, open
hatch.
Cable glands (Data Bus - Power sup. - Input/Output)
J6
Use this (on RS485 connection) when the distance of the data cable is near or over 100 m / 328.08 ft and the signal is
J9
J7
J14
IN 1-2-3-4
OUT 1-2-3-4
V- opt
V+ opt
DATA1
Data or D0 Channel 1 or Tx (RS232) or L+ (RS485)
CLK1
Clock or D1 Channel 1 or L- (RS485)
DATA 2 / CLK2
Data/Clock or D0/D1 Channel 2
DATA 3 / CLK3
Data/Clock or D0/D1 Channel 3
DATA 4 / CLK4
Data/Clock or D0/D1 Channel 4
ALIM
GND
© STid - 20 PA des Pradeaux FR13850 Gréasque - NI1132X01 - Page 2 sur 24 - Ed. 21/02/2024
STid reserves the right to make change without notice, for the purpose of product improvement.
SPECTRE Access UHF
Installation procedure
only
the hatch provided for this purpose by unscrewing the 4 captive screws without removing them from the
Green LED
Red LED
weakened (polluted signals, frame errors etc.).
Micro USB connector for configuration purposes only
Use this connector for earth connection purpose
Read-only
Low polarization potential of opto-coupled inputs and outputs
High polarization potential of opto-coupled inputs and outputs
UHF SPECTRE Access
Notice d'installation
Host Connection
Front View of the module
RF port 1
RF port 2
TTL / RS232 / RS485 Connection
End of line resistor RS485
TTL output level: +5V or Vin
OSDP
TM
4 opto-coupled inputs
4 opto-coupled outputs
L+ (RS485)
L- (RS485)
Power supply
GND
UHF SPECTRE Access
Manual de instalación
RF port 3
RF port 4
Tx (RS232) or L+ (RS485)
Rx (RS232) or L- (RS485)
Not used
Not used
Not used
US
FR
ES
SSCP
®
