Idiomas disponibles
Idiomas disponibles
Choosing the set-up location
WARNING!
For all set-up variants, observe the safety
distances to combustible materials (see
Figures F, I, M)
• With all set-up variants, make sure that it is an appropriate
location, so you do not have to move the SPIN after lighting it.
WARNING!
When used indoors, observe the
specifications for room size, operating time
and ventilation under "Notes on room size"!
SET UP THE SPIN AS A TABLE-TOP FIRE
(FIGURES E, F, G)
Legend:
1.
Extinguishing cover
2.
Glass cylinder
3.
Body
4.
Stand
5.
Eco-Ring
6.
Bio-Burner
• Screw the body onto the stand.
• Place the SPIN on a flat and stable surface.
• Insert the Bio-Burner into the body.
• Place the glass cylinder on the body.
• Follow the instructions under "Lighting the fire"!
EN
.
HANGING THE SPIN AS A HANGING FIRE
(FIGURE L, M, N, O)
Either you have already purchased the SPIN as a SPIN hanging fire
or you can convert your SPIN to a SPIN hanging fire with the hanger.
Legend:
1.
Extinguishing cover
2.
Glass cylinder
3.
Body
4.
Stainless steel cable with hook and clamp element
5.
Hanger
6.
Mounting material (eye bolt 6X45, expansion dowel)
7.
Allen key for clamping element
8.
Eco-Ring
9.
Bio-Burner
• Use the the SPIN body for the conversion without the base and
without additional riser.
NOTICE
The SPIN should be hung in a cantilevered
manner from a ceiling or truss. It may only
be installed on solid concrete ceilings or
solid wood, as this is the only way to ensure
that the eye bolt is sufficiently strong.
Installing on concrete
• For secure attachment to concrete, a pre-drilled hole with Ø 10
x 60 mm must be made at the intended location.
• For secure attachment, use the eye bolt with dowel included in
the scope of delivery.
• The screw must withstand a tensile force of at least 60 kg.
Consult an appropriate specialist for the installation.
Installing on wood
• For secure attachment on solid wood, a pre-drilled hole with Ø
4 x 60 mm must be made at the intended location.
• Use the eye bolt included in the scope of delivery for secure
attachment.
How to install the SPIN as a hanging fire
• Screw the body into the thread of the hanger (Figure N1).
• Connect the hook on the loop of the stainless steel cable to the
hanger.
• Adjust your SPIN hanging fire to the desired height with the
help of the infinitely adjustable stainless steel cable (Figure O).
To do this, open the Allen screw on the clamping element.
• When tightening the screw again, ensure that there is sufficient
clamping force. The easiest way to check this is by pulling the
lower end of the frame.
• Make sure that the stainless steel cable is not kinked;
otherwise permanent deformation may occur.
• Insert the Bio-Burner into the body (Figure N2).
• Place the glass cylinder on the body (Figure N3).
• Follow the instructions under "Lighting the fire".
NOTICE
Adjusting the height of the SPIN hanging
fire and hanging it must always be done
without the glass cylinder.
