RIDGID 916 Manual página 16

916 Roll Groover
Removing or Installing Drive Roll
1. Remove 4 bolts that hold rear bearing retaining plate
and remove plate. (Figure 17)
Figure 17 – Remove Retaining Plate
2. With mallet, lightly tap on front of drive shaft to release
shaft and rear bearing from unit.
3. Pull drive shaft and bearing from unit, and replace with
proper shaft.
NOTE! Replacement drive shaft come equipped with
rear bearing.
Service And Repair
WARNING
Improper service or repair can make the machine
unsafe to operate.
The "Maintenance Instructions" will take care of most of
the service needs of this machine. Any problems not
addressed by this section should only be handled by a
RIDGID Authorized Independent Service Center. Use
only RIDGID service parts.
For information on your nearest RIDGID Authorized Inde-
pendent Service Center or any service or repair questions,
see Contact Information section in this manual.
14
Optional Equipment
WARNING
To reduce the risk of serious injury, only use acces-
sories specifically designed and recommended for
use with the RIDGID 916 Roll Groover, such as those
listed below.
Catalog Model
No. No. 916 Accessories
45347 — Roll Set for 1" Schedule 10, 40 (Optional)
45352 — Roll Set for Copper (Optional)
69667 — Roll Set for 1 1 / " - 1
4
69692 — Roll Set for 2" - 6" AWWA (Optional)
67662 — Adapter Bracket for 300 Compact
76822 — English Diameter Tape
76827 — Metric Diameter Tape
For a complete listing of RIDGID equipment available
for these tools, see the Ridge Tool Catalog online at
RIDGID.com or see Contact Information.
Disposal
Parts of the 916 Roll Groover contain valuable materials
and can be recycled. There are companies that specialize
in recycling that may be found locally. Dispose of the
components in compliance with all applicable regulations.
Contact your local waste management authority for more
information.
1 / " AWWA (Optional)
2
999-998-693.10_REV. B