Antar AT52304 Manual De Usuario página 16

ENG
BATTERY CHARGING.
An external charger is part of the wheelchair's equipment. The charger enables the ba ery to be
charged quickly and easily, ensuring its trouble-free opera on.
NOTE: Wheelchair ba eries should only be charged using the charger provided. Do not use chargers
for vehicle ba eries. Before fi rst use, charge the ba ery fully fi rst, not exceeding an 8-hour charging
cycle.
THE WAY THE BATTERIES ARE CHARGED:
• Ensure the control panel is off and the wheelchair wheels are locked.
• Plug the charger plug into the socket located on the control panel (Figure 15).
• Insert the charger plug into the wall socket.
• The start of charging is indicated by a red LED on the charger. The ligh ng of the red, yellow and 3
green LEDs indicates that the ba ery is fully charged.
• The dura on of a full charging cycle is between 8 and 12 hours.
• When charging is complete, fi rst disconnect the charger plug from the wall socket and then the other
plug from the driver socket. When charging is complete, the charger with cables and plugs should be
placed in the bag located at the back of the backrest.
In the event of overloading the motors, there is an overload protec on system that cuts off the power
supply to protect the motors and the electrical installa on. Restoring opera on once the protec on
system has been ac vated requires the interven on of a specialist - remove the screws located on the
ba ery compartment, replace the fuse and then reapply the ba ery compartment cover.
SAFETY BELT
To ensure your safety, remember to wear your seatbelt every me you use the wheelchair.
PRECAUTIONS
Ensure that the controller is correctly installed and that the handlebar is in the central posi on,
poin ng ver cally upwards. The user should sit in the wheelchair, fasten the seat belt and rest the
back against the backrest.
When the power is switched on, fi rst check that the maximum speed indicated by the controller lamp
is suitable for your needs. If it is necessary to change the maximum speed, adjust it using the up or
down speed bu on on the control panel. For safety reasons, it is recommended to start adjus ng
the maximum speed from lower values. In the event that the wheelchair starts to move accidentally,
immediately release the handle, which will stop the engine.
Note: The user's feet must be on the footrests.
Note: Keep your forearms on the armrests when using the wheelchair.
Note: Make sure the wheels are locked before using or pu ng away the product.
DANGER
The use of a wheelchair is prohibited:
1.When expressly forbidden in this manual, i.e. driving on steep gradients, overcoming excessively high
off -road obstacles, driving on motor vehicle traffi c routes, etc.
AT52304 insA6_multi.indd 16 AT52304 insA6_multi.indd 16
15
- 16 -
16
2023-12-22 13:27:24 2023-12-22 13:27:24