Battery Charging - Nobles Speed Scrub 2401 Manual Del Operador Y Piezas

OPERATION
FIG. 22
2. Rinse out solution tank and solution flow system
with clean water after each use. This will prevent
clogging due to chemical buildup.
3. Reconnect solution tank drain hose securely after
draining.

BATTERY CHARGING

NOTE: Recharge batteries ONLY after a total of 30
minutes of use or more. This will prolong battery life.
The following charging instructions are intended
for chargers supplied with machine. Only use a
charger with the following specifications to
prevent battery damage.
CHARGER SPECIFICATIONS:
S
OUTPUT VOLTAGE - 24 VOLTS
S
OUTPUT CURRENT - 25 AMPS MAXIMUM
S
AUTOMATIC SHUTOFF CIRCUIT
S
FOR DEEP CYCLE BATTERY CHARGING
NOTE: For optimum machine operation, keep
batteries charged at all times. Never let batteries set in
a discharge condition.
WARNING: Batteries emit hydrogen gas.
Explosion or fire can result. Keep sparks and
open flame away. Keep battery compartment open
when charging.
FOR SAFETY: When servicing machine, wear
protective gloves when handling batteries and
battery cables. Avoid contact with battery acid.
1. Transport machine to a well–ventilated area for
charging.
2. Turn main switch to the off position.
12
Home Find... Go To..
3. Hinge open recovery tank to access batteries.
Make sure recovery tank is empty before opening
(Figure 23).
FIG. 23
4. Check fluid level (A) in each battery cell. Do not
charge batteries unless fluid is slightly covering
battery plates (B). If needed, add just enough
distilled water to slightly cover plates. DO NOT
overfill. Batteries can overflow during charging due
to expansion. Replace cell caps before charging
(Figure 24).
A
FIG. 24
5. Plug charger DC output connector to battery
connector located near battery compartment. Flip
up tank support stand and rest tank on stand
(Figure 25).
FIG. 25
NOTE: Once charger is connected to machine,
machine becomes inoperable.
Speed Scrubt 2401/2601 (08–01)
B