Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUcTIONS (See Figure 2)
1. Ensure that the pressure to the air inlet of the regulator from air line does not exceed
the maximum pressure specified in the instructions.
2. Before applying inlet pressure, pull the adjustment upwards until you hear the click,
turn it counterclockwise to release all force on the regulating spring. Then push the
adjustment downwards until you hear the click.
3. Air inlet pressure can be approached by turning the adjustment. Pull the adjustment
upwards until you hear the click, turn it clockwise to increase the pressure or
counterclockwise to decrease the pressure. When the desired pressure is obtained,
pull the adjustment downwards until you hear the click to secure the adjustment.
4. Adjust the air pressure using the T-Handle by turning it clockwise to increase pressure
or counterclockwise to decrease pressure. Loosen the lock nut before pressure
adjustment and tighten the lock nut after you finish the pressure adjustment.
5. The set air pressure can be read on the pressure gauge.
6. Always approach the desired pressure gradually, either from a lower pressure to a
higher pressure, or from a higher pressure to a lower pressure.
DIAGRAMS
4
MAINTENANcE
Maintenance Steps
1
disassembly (See figure 2)
• Regulator can be disassembled without removal from air line.
• Shut OFF inlet pressure. Reduce pressure in inlet and outlet lines to zero.
• Turn adjustment fully counterclockwise.
• Disassemble in general accordance with the parts illustrated in Figure 2.
2
cleaning (See figure 2)
• Clean parts with warm water and soap.
• Rinse and dry parts. Blow out internal passages in body with clean, dry
compressed air.
• Inspect parts. Replace those found to be damaged.
3
assembly (See figure 2)
• Lubricate o-rings, bore in bottom plug, valve stem, adjusting screw threads and
tip and the outer circumference and both sides of the thrust washer with a light
coat of good quality o-ring grease.
• Assemble the unit as shown on Figure 2.
figure 1
Torque Table
Parts Ref. No.
Inch Pounds (N-m)
Screw (a),Screw (b)
20 to 30 (2.3 to 3.4)
Bottom plug
20 to 30 (2.3 to 3.4)
5
