Idiomas disponibles
Idiomas disponibles
MOUNTING THE TILTING WORKTABLE ASSEMBLY
1. Position table-support bracket so that the "pivot pin" fits into the corresponding hole on the
sander frame and the radius slot aligns with the threaded hole in the frame.
2. Place washer on threaded shaft of knob, insert through radius slot, and tighten into threaded
hole.
3. Adjust table to angle desired for sanding task.
4. To avoid trapping the workpiece or your fingers between the table and disc, adjust the position of
the table on its mounting bracket to maintain a gap of no more than 2 mm.
INSTALLING THE BACKSTOP
1. Position the backstop against the belt frame so that the slot aligns with threaded hole in frame.
2. Secure the backstop to frame with 2 x socket head screws, washers as shown. Do not overtighten.
•
The gap between the sanding belt and the backstop should be no more than 2mm.
EN
