Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7a. Find Top drawer front (8), Drawer back panel (13) and Drawer bottom
panel (10).
7b. Match up "G" label on Drawer bottom panel (10) with "G" label on Top
drawer front (8) ,"H" label on Drawer bottom panel (10) with "H" label
on Drawer back panel (13) and click together. Make sure there are no
gaps between the three panels.
8a. Find Left side drawer panel (11) and Right side drawer panel (12).
8b. Match up "I" label on Drawer bottom panel (10) with "I" label on Left
side drawer panel (11), then match up "J" label on Drawer bottom pan-
el (10) with "J" label on Right side drawer panel (12) and click together.
Make sure there are no gaps between the three panels.
Note: All drawers are assembled the same way.
9. Peel and stick four silicone pads (21) onto the inside corners of each
drawer, Then attach the drawer box to the base cabinet.
Note:
1. If you need to remove the drawer, please press the Release Levers on
the mechanisms pre-attached underneath the drawer kit at both ends.
2. If necessary, you can push the Adjustment Clips on the bottom
mechanisms to adjust the top and bottom gaps of the drawer.
Hardware Used
21
Silicone pads
7
13
H
G
H
10
8
Click
8
I
I
8
11
Click
9
21
1
x 8
Release Lever
Adjustment Clip
6
ASSEMBLY INSTRUCTIONS
Toe Kick Assembly Instructions
NOTE: Toe Kick need to be purchased separately.
10a. Install Front clasp (15) in front of the base cabinet leg, then install the
appropriate length size of the Toe Kick and press down the clasp to
Click
secure the Toe Kick.
10b. Install Side clasp (14) in side of the base cabinet leg, remove the
protective film from 3M adhesive paper on the side clasp, then attach the
appropriate length size of the Toe Kick to the clasp, press to make sure
it sticks firmly.
G
Hardware Used
14
Side clasp
15
Front clasp
DISASSEMBLY
Click
J
J
12
1
8
9
10
14
x 4
x 2
RELEASE KEY
1. Insert the release key into the triangle hole.
2. The release key needs to be fully inserted.
3. You will need more than 1 for some panels.
4. It is importand that release key in the sides
meet each other so that you are sure the
frame is fully unlocked.
2
3
7
15
