camry Premium CR 2844 Manual De Uso página 5

14.In order to provide additional protection, it is recommended to install residue current
device (RCD) in the power circuit, with residual current rating not more than 30 mA.
Contact professional electrician in this matter.
15.If using the device in bathroom after use remove the power plug from the socket,
because water proximity presents risk, even if the device is turned off.
16. Do not allow the device or power adaptor to wet. If the device falls into water,
immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
17. Do not touch the device or power adaptor with wet hands.
18. The device has to be turned off after every use.
19. Do not leave switched on equipment or adapter without supervision.
20. Never use this device close to water, e.g.: Under shower, in bathtub, or above sink
filled with water.
21. If the device utilises a power adaptor, do not cover it, because this can cause a
dangerous temperature rise and can damage the device. Always connect the power
adaptor cable to the device, and then connect the power adaptor to the power socket.
22. The cutting scissors are very sharp. Use caution when assembling, dismantling and
cleaning. Do not touch any elements of the moving blade during the operation!
23.DO NOT CHARGE THE BATTERY FOR LONGER THAN 48 HOURS – this can cause
irreversible damage to the battery.
24. The charging process should be conducted in temperatures between 5-35 degrees
Celsius.
25.Do not wash the blades in water.
26.Only change comb attachments when the device is switched off.
PRODUCT DESCRIPTION:
1. Blade 2. On/off button 3. LED display 4. Charging port 5. Comb (3 / 6 / 10 / 13 mm)
6. Cutting head cover 7. Cleaning brush 8. Machine oil 9. USB charging cable 10. Hanging loop
BATTERY CHARGING:
To start charging, connect the power cable to the charging socket (4) and the charging cable to the 5V 1A power supply.
Then connect the power adapter to a power source.
Charging time is about 4 hours. Then the product is fully charged, the working time is about 3 hours.
USING THE MACHINE
Select the desired cutting length using the cutting length adjustment lever: 0.8 / 1.2 / 1.6 / 2.0 mm.
You can also attach one of the attachments to the blade. The length adjustment lever can also be used to increase the length. The
length shown in the attachments is the length at the lowest setting of 0.8 mm.
Changing the blade:
1. Turn off the device.
2.Undo the screws on the old blade and remove the bottom blade from the top moving blade (Picture 5A page 3.) To do this use a
Philips star screwdriver.
3. The blade can now be removed for cleaning or replacement.
4. To re-assamble, place the new blade so the holes in the blade and the holes in the device are in parallel with eachother
5. Reinsert the two screws.
5