Idiomas disponibles
Idiomas disponibles
4-1 (Fig.9) Press the Release button (8) of the
tool and confirm that the Release button is
caught in the Release stopper (9).
4-2 (Fig.11) Rotate the Magazine stopper (6) to
open the Magazine cover.
4-3 (Fig.21) Remove the Tiewire from the
Magazine.
4-4 (Fig.22) Remove the wire with the plastic
piece from the Wire guide.
5. When the Tiewire runs out
(Fig.28) The plastic piece comes off when it is
used up normally, and can be discarded
separately as plastic and metal wire. (About 40
cm remains after normal use)
(Fig.6) Set the Main switch (f) at "OFF", the
Trigger lock (2) at "LOCK" and remove the
Battery pack (5).
6. Tension adjustment
(Fig.29.c) This dial allows you to adjust wire
tension torque slightly. To increase the tension,
turn it in the counterclockwise. To decrease the
tension, turn it in the clockwise.
7. Auto Power-off feature
This tool has "Auto Power-off" feature, which
saves the power consumption of the Battery
when the tool is not operated.
If the tool is not operated for 30 minutes, the tool
is automatically turned off. When the power is
turned off automatically, turn the Main switch
OFF and ON again to operate the tool.
8. For proper tightness
8-1 (Fig. 26) Tilt the tool 45° angle to the crossed
rebars.
8-2 (Fig.27) Align the Center mark (a) to the
center of the crossed rebars.
8-3 (Fig.30) Apply the tool perpendicularly to the
surface of the crossed rebars.
During tool operation
Do not move the tool during tying operation until
the tool stops tying automatically.
8-4 (Fig.31) Tie in alternate direction.
8-5 (Fig.32) Cross tying.
Bent the knot of the first tie before making
the second tying.
9. How to reload previously used
Tiewire
(Fig.33) Without twisting the 2 wires, insert them
into the Wire guide (Fig.1.l).
10. How to reload the Tiewire using
the Loading assist button
• Do not use this function if the surrounding
is too noisy to hear the tool's beep sound.
• Make sure that the Magazine cover is
closed when you start using this function.
• Confirm that the Window (Fig.1.j) is
closed by tightened Hex bolt (Fig.1.m).
An alarm will sound when the Tiewire runs out.
10-1 Set the Main switch (Fig.1.f) at "OFF" to
stop the alarm.
CAUTION
• Wear safety gloves.
• Never open the Magazine cover until the
Loading assist button pressed.
10-2 Set the Trigger lock (Fig.1.2) at "LOCK"
and Main switch at "ON".
10-3 If you set the Main switch at "ON" and press
the Loading assist button (Fig.20.e), a
"piro, piro, piro" sound will notify that the tool
entered "Loading mode".
• "Loading mode" is canceled if 2 minutes
elapse or if you press the Loading assist
button.
• If you press the Loading assist button
again, the tool enters "Loading mode".
Note that the wire is not ejected.
• "Loading mode" will start if you press the
Loading assist button after done tying as
well as immediately after turning the Main
switch at "ON".
10-4 For subsequent operations, read P.18,
(2-5).
13.STORAGE AND
MAINTENANCE
Do not store the tool in a cold weather
environment. Keep the tool in a warm area.
When not in use, the tool should be stored in a
warm and dry place. Keep out of reach of
children.
19
