Idiomas disponibles
Idiomas disponibles
completely but to leave it slightly open, depending
on how the chimney draws, to achieve slow
burning for a maximum of 10 hours. With a good
drawing chimney the air wash control n° 1 will
need to be closed further than with poor drawing
chimneys.
3.3. ASH REMOVAL
IMPORTANT! Only handle the ash pan when
the stove is cold. Always avoid opening the
ash-pan if your stove is in operation.
Empty the ash pan regularly to prevent the ash
from spilling over. Do not allow ash to build up
and touch the under side of the grate. A layer of
ash left over the grate when burning wood will
protect the grate, retain heat, and promote clean
combustion.
To clean the ash from the stove, use the poker
provided. Besides, the grate can be riddled to
encourage ash to fall into the ash pan. The riddling
rod is located at the top rear of the stove (nº4 -
Fig. 6). With the tool provided, you can operate
the knob pulling from left to right to shake the grill.
4
To remove the ash from the stove, open the
ashpan door by turning clockwise the handle.
Remove the ashpan and empty it. Put the ashpan
back and close the ashpan door by turning the
handle counterclockwise. This door must be
closed to prevent damage to the stove.
Use the glove and hold ash pan on both sides.
Place ashes in a metal container with a tight fitting
lid. The closed container of ashes should be
placed on a non-combustible floor or on the
ground, well away from all combustible materials,
pending final disposal. Ashes should be removed
from ash pan when cold.
Fig. 6
3.4. RELOADING THE STOVE
It possible use the loading door.
To prevent smoke blowing into the room follow
these recommendations:
Close air wash control n° 1, and open door
open the damper nº 3. Rake the embers
towards the front of the stove and spread
evenly. If there are logs only partially burned
rake these to the front of stove.
Feed the logs to the embers. Load logs evenly
across the base being cautious not to place
wood in front of the rear edge of the log guard.
Open the air wash control n° 1 to its maximum,
open the stove door a fraction and leave to
burn for 5 to 10 minutes. Then close the stove
door close the damper nº 3.
Adjust the air wash control n° 1 depending on
the tempo of the stove required.
High combustion temperatures are the secret
to clean glass operation. When loading wood
add one or two logs at a time depending on
size. Loading the appliance full of damp wood
on a low fire, is certain to cause low combustion
efficiency resulting in tar and dirty glass.
Note : always allow the stove to recover before
closing for long burning.
3.5. THERMOSTAT SETTING.
This operation must be carried out with the
appliance cold, with the thermostat knob set to
minimum.
3.6. FUEL
Recommended solid fuels: hornbeam, beech
wood, oak wood, fruit tree wood, birch wood
and smokeless fuel designated to be suitable
for use in a closed appliance.
Fig. 7
