HP OneShred Auto 200CC Manual página 18

EN
Major Paper Jam in the Manual Infeed
1
Switch the device off by pressing the "Power (On/Off)" button.
2
Disconnect the power plug from the power socket.
3
Wait at least 40 minutes until the thermal overload protection has reset.
4
Connect the power plug to a power socket.
5
Switch the device on by pressing the "Power (On/Off)" button.
6
Press the "Reverse" button.
7
Pull the material out of the shredder.
Î You have cleared the paper jam.
After the material has been removed from the shredder, the cutting mechanism continues to
run for 3 seconds to clean itself. Wait until the shredder has stopped and the status indicator
lights up blue.
Oiling the Cutting Mechanism
If you want to increase the working life of the shredder, you should oil the shredder's cutting
mechanism at regular intervals.
Special oil and oiled sheets are available for the shredder from HP.
Important!
Risk of property damage through using the wrong oil! Do not use spray oils. Only use a special oil
intended for shredders.
There are various ways to oil the cutting mechanism.
Oiling Using Self-Oiled Paper:
1
Apply the special oil for shredders in several lines horizontally across a sheet of paper.
2
Insert the oiled sheet of paper in the insertion slot.
Î The paper with oil applied is inserted and oils the cutting mechanism.
Oiling Using Oiled Sheets
1
Insert the oiled sheet in the paper infeed.
Î The paper with oil applied is inserted and oils the cutting mechanism.
- 18 -