Idiomas disponibles
Idiomas disponibles
CAUTION!
• ALWAYS turn off the instrument before replacing the batteries.
• ALWAYS remove the batteries if the instrument is not to be used for
extended periods.
• ALWAYS use high quality batteries of the same brand, type and age.
• If the instrument does not work properly, or the low battery icon is displayed,
replace the batteries immediately.
• DO NOT expose the batteries or instrument to extreme temperatures or direct
heat source, as this can cause the batteries to leak.
• If the batteries should leak, remove them using a cloth and dispose of them
according to local regulations. Clean any leaked battery acid avoiding any contact
with skin, eyes & mouth.
• If any contact does occur, rinse affected areas immediately with fresh water and
seek medical advice.
Functions and settings
01
Operation instructions
1. Press
to turn ON.
2. Press
to switch between "cumulative" and "area" modes, and to select front or rear datum measurement.
3. Press
&
together to switch between metric and imperial units.
In single measurement mode:
4. Press
to turn on the laser. The laser will turn off automatically after 20s if no measurement is taken.
5. Point the laser at the target and press
6. Repeat steps 4 and 5 to take the next measurement. The screen will display the current, and the 2 previous readings.
7. Press and hold
for approximately 2 seconds to enter continuous measurement mode.
In cumulative measurement mode:
8.
total distance, the last measurement, and the new total distance.
In area measurement mode:
9. Press
to turn on the laser.
10.
11. Point the laser at the second target and press
the total area.
12. Press and hold
to switch OFF. The device will switch off automatically after 5 minutes if no buttons are pressed.
again to record the distance.
again to record the distance.
again to record the distance. The screen will display the 2 measurements and
The screen will display the last
6
