Idiomas disponibles
Idiomas disponibles
EN
(Original instructions)
DESCRIPTION
A
Water spray button
B
Carrying handle
C
On/off button
D
Clean water tank
E
Dirty water tank
F
Hose
G
Water suction nozzle
H
Nozzle release button
I
Power cord storage
J
Plug
K
2 en 1 crevice tool holder
L
Silicone brush
M
Hard brush
N
2-in-1 crevice tool
USE AND CARE:
Before each use, fully extend the power cord of the
appliance.
Do not use the appliance if its accessories are not
properly attached.
Do not use the appliance if the accessories
attached to it are defective. Replace them
immediately.
Do not use the appliance if its start/stop device
does not work.
Do not use detergent that generates foam.
Do not use the appliance without putting the dirty
and clean water tanks correctly.
Keep this appliance out of the reach of children
and/or persons with reduced physical, sensory
or mental capabilities or lack of experience and
knowledge.
Do not operate in areas containing metal objects
such as nails and/or screws.
Never vacuum incandescent or sharp objects
(cigarette butts, ashes, nails...).
Do not use the appliance on pets or animals.
Keep the appliance in good condition. Check that
moving parts are not disassembled or jammed, that
there are no broken parts or other conditions that
may affect the proper functioning of the appliance.
INSTRUCTIONS FOR USE
NOTES BEFORE USE:
Ensure that you have removed all packaging
material from the product.
Confirm that the device and all accessories are
included and correct.
USE:
Fully extend the power cord before plugging in.
Remove the hose (F) from the body of the
appliance, assembly the water suction nozzle (G)
or 2 in 1 crevice tool (N).
Filling the clean water tank (D) up to the maximum
level.
Add the detergent (IMPORTANT: do not use
detergents that generate foam).
Plug in the appliance.
Switch the appliance on by pressing the on/off
button (C).
Stop the appliance by pressing the on/off button
(C) again.
AFTER THE DEVICE HAS BEEN USED:
Unplug the appliance from the mains.
Empty the dirty water tank (E).
Collect the power cord, hose and accessories.
CLEANING
Unplug the appliance from the mains and allow it to
cool down before cleaning.
Do not use solvents, products with an acid or basic
pH factor such as bleach, or abrasive products to
clean the appliance.
Do not allow water or other liquids to enter through
the ventilation openings to prevent damage to the
internal working parts of the appliance.
Do not immerse the appliance in water or any other
liquid, nor put it under the tap.
EMPTYING THE DIRTY WATER TANK:
Empty the dirty water tank (E) at the end of each
use.
Remove the dirty water tank by pulling the handle
upwards.
Open the lid and pour the liquid into a suitable
place.
During use, if the dirty water in the tank exceeds
the maximum level, stop operation immediately
and empty the dirty water tank before using the
appliance.
EMPTYING THE FRESH WATER TANK:
Empty the fresh water tank (D) at the end of each
use.
Remove the fresh water tank by pulling the handle
upwards.
Open the lid and pour the liquid into a suitable
place.
CLEANING THE SUCTION NOZZLES:
Separate the nozzle from the hose by pressing the
