Craftsman 917.28852 Manual Del Operador página 13

REVERSE OPERATION SYSTEM (ROS)
Your tractor is equipped with a Reverse
Operation System (ROS). Any attempt by
the operatorto travel in the reverse direction
with the attachment clutch engaged will shut
off the engine unless ignition key is placed
in the ROS "ON" position.
_WARNING: Backing up with the at-
tachment clutch engaged while mowing is
strongly discouraged, Turningthe ROS "ON",
to allow reverse operation with the attach-
ment clutch engaged, should only be done
when the operator decides it is necessary to
reposition the machine with the attachment
engaged. Do not mow in reverse unless
absolutely necessary,
USING THE REVERSE OPERATION
SYSTEM -
Only useifyou arecertain no chiidren or other
bystanders will enter the mowing area.
1. Move motion control lever to neutral
position,
2. With engine running, turn ignition key
counterclockwise to ROS "ON" posi-
tion.
3, Look down and behind before and while
backing.
4. Slowly move motion control lever to
reverse (R) position to start movement.
5, When use ofthe ROS is notongerneeded,
turn the ignitionkey clockwise to engine
"ON" position.
ROS "ON" Position
Engine "ON" Position
(Normal Operating)
TO OPERATE ON HILLS
,_WARNING: Do not drive up or down
hills with slopes greater than 15° and do not
drive across any slope. Usethe slope guide
provided at the back of this manual.
• Choosetheslowestspeed before starting
up or down hills.
• Avoid stopping or changing speed on
hills.
• If stopping is absolutely necessary, push
clutch/brake pedal quicktyto brake position
and engage parking brake.
• Move motion control lever to neutral posi-
tion,
13
IMPORTANT: The motion control lever does
not return to neutral position when the clutch!
brake pedal is depressed.
o Torestart movement, slowly release park-
ing brake and clutch/brake pedal.
• Slowly move motion control lever to slow-
est setting.
• Make all turns slowly.
TO TRANSPORT
When pushing or towing your tractor, En-
sure to disengage transmission by placing
freewheel control in freewheeling position.
Freewheel contro] is located at the rear
drawbar of tractor,
1. Raise attachment lift lever to its highest
position.
2. Pullfreewheel control out and into the slot
and release so it isheld inthe disengaged
position,
• Do not push or tow tractor at more than
two (2) MPH.
• Tore-engagetransmission, reverseabove
procedure.
TRANSMISSION ENGAGED
TRANSMISSION DISENGAGED
NOTE: To protect hood from damage when
transporting your tractor on atruck or a trailer,
Ensure hood is closed and secured to tractor.
Use an appropriate means of tying hood to
tractor (rope, cord, etc.).
TOWING CARTS AND OTHER ATTACH-
MENTS
Tow only the attachments that are recom-
mended by and comply with specifications
of the manufacturer of your tractor, Use
common sense when towing. Too heavy of
a load, while on a slope, is dangerous. Tires
can lose traction with the ground and cause
you to lose control of your tractor,