Idiomas disponibles
Idiomas disponibles
EN
INSTRUCTION MANUAL
PRODUCT'S PRESENTATION
This Automotive Diagnostic Leak Detector
is designed for test leaks in vehicle pipe sys-
tems. It could be used on all cars, motorcycles,
snowmobiles, ATV, light trucks, boats, etc.
SAFETY INSTRUCTIONS
Read carefully this owner's ma-
nual before using the product.
Failure to comply with these ins-
tructions could result in personal
injury and/or damage
to the product.
Please keep the instructions for
future reference.
TECHNICAL SPECIFICATIONS
Power supply: 12V vehicle battery
Flow rate: <10L/min
Test pressure: 15psi
High temperature protection: YES
PARTS LIST
ASSEMBLY
1. Connect the power cords to the correspon-
ding power inlets, ensuring the red plug aligns
with the red socket and the black plug with the
black socket.
2. Attach the smoke tube to the smoke out-
let, securing it with the quick clamp. REMIN-
DER: Use the Velcro Strap to bundle the power
cords and smoke tube for storage.
3. Open the oil filter port, pour smoke oil into
the reservoir, and monitor the Oil Level Indica-
tion Window. Ensure the oil level stays below
the MAX line. If overfilled, invert the unit to drain
excess oil.
4. The unit is now ready for use. Keep an eye
on the oil level indication Window; if it approa-
ches the bottom, a refill is necessary.
OPERATION
Test Run
1. Connect the Power Cords to the 12V vehicle
battery, with the red clamp on the positive ter-
minal.
2. Activate the Power Indicator to start air
pressure generation.
3. Seal the smoke nozzle on the Smoke Tube
with your fingertip to observe real-time output
pressure on the Pressure Gauge.
4. Turn on the smoke mode switch, and confirm
smoke production with the illuminated smoke
mode indicator.
Universal Intake adaptor
1. Clean the inner wall of the intake opening
while air filter, and the throttle connections are
removed, so as not to scratch the adapter.
2. Close the pressure relied Valve (A) next to the
hand pump (B).
3. Put the rubber component (C) into the intake
opening.
4. Inflate the rubber component (C) by pres-
sing the hand pump (B) till the intake opening
is tightly sealed.
5. Now the system is ready to test, introduce
air/smoke into the system by plug the smoke
nozzle into the Tube opening (D)
6. After test, pull of smoke nozzle release the
inflated air by open the Pressure Relief Valve (A)
next to the Hand Pump (B).
7. Clean the adapter for storage, avoid con-
tact with corrosive liquids.
Generic operation
1. Turn off the ignition of the vehicle. Leak test
of vehicle systems require the engine to be off.
2. Unmount the air filter, and the Throttle con-
nections.
· 4 ·
REF.54524
