Idiomas disponibles
Idiomas disponibles
RIGGING
Controller Installation
Install the device in a well-ventilated area.
Only install the controller on scratch resistant surfaces.
This device is constructed for a standing installation only.
OPERATION
When installing the device, make sure there is no highly-inflammable
material (decoration articles, etc.) within a distance of min. 0.5 m.
Connect the connection-cable ends with the sockets of the LED luminaries and the controller.
Connect the system to the mains with the power-plug.
With the POWER-switch, you can switch the device on and off.
You can select the programs by pressing the buttons on the controller.
Attention: The controller can be used with at least 4 and up to 8 luminaries.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
DANGER OF FIRE!
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
12/23
51930475_V_1_1.DOC
