heating element with the control
indicated below.
- Pay attention to easy to reach
device parts as they over-heat
during use.MAKE SURE TO KEEP
CHILDREN AWAY FROM THESE.
- Avoid spilling liquids like, for
example, oil or other types of
grease, as they can cause fires.
- Do not attempt to put fires out
using water. Turn off the hob and
cover the flame with a lid or fire-
proof blanket.
- Do not leave objects on the
cooking surface, it may cause
fires.
- If cable is damaged, have
qualified personnel or After-
Sales Service replace it.
- Steam cleaners must not be
used.
- If the surface is cracked, switch
off the appliance to prevent
electric shock.
- This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental
capabilities or lack of experience
and knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved. Children
shall not play with the appliance.
Cleaning and user maintenance
shall not be made by children w
thout supervision.
- The appliance is not intended
to be operated by means of
external timer or separated
remote-control system.
- Using unsuitable protective
devices may cause accidents.
Please make sure to use only
protective devices which are
approved by the manufacturer
or supplied with the device.
INSTALLATION INSTRUCTIONS
These instructions address specialised installers and
serve as a guide for installation, adjustment and
maintenance in conformity with the laws and regula-
tions in force. If a built-in oven or any other appliance
that generates heat must be fitted directly under the
glass-ceramic cooktop, THIS APPLIANCE (oven) AND
THE GLASS-CERAMIC COOKTOP MUST BE SUITABLY
INSULATED in such a way that the heat generated
by the oven, measured on the bottom right of the
cooktop, does not exceed 60°C. Failure to respect this
precaution may determine improper functioning of
the TOUCHCONTROL system.
• Positioning (Fig.1):
The domestic appliance is designed to be built into a
worktop as illustrated in the specific figure. Apply seal-
ant around the entire perimeter (cut-out dimensions
Fig.1B). Fix the domestic appliance on the worktop by
means of the 4 brackets provided, taking the thickness
of the worktop into account (Fig.1A). If the lower part
of the appliance, after installation, is accessible via
the lower part of the cabinet then it is necessary to
mount a separator panel respecting the distances
indicated (Fig.1C). If the appliance is installed with an
oven underneath then the separator is not necessary.
• Electrical connections (Fig.5):
Before making the electrical connections, check that:
- The ground cable is 2 cm longer than the other cables;
- The system ratings meet the ratings indicated on
the identification plate fixed on the lower part of the
worktop;
- The system is fitted with efficient earthing compliant
to the laws and regulations in force.
If the appliance is not supplied
with a cable, use a cable of type:
"H05V2V2-F", that has a cross-
section suitable for the total pow-
er consumption of the device.
The cable should never reach a temperature which
is 50°C above the temperature of the room in which
it is installed.
The appliance is to be per-
manently connected to the
electrical mains, therefore
an omnipolar switch must be
inserted, enabling complete
disconnection under the condi-
tions of overvoltage category
III; it must be fitted between
the appliance and the power
supply, sized according to the
load and in compliance with
the standards in force
(the yellow/green earth wire must not be interrupted
- 13 -