Idiomas disponibles
Idiomas disponibles
off during brushing. When pausing longer
than 30 seconds, the timer resets to the initial
starting point.
The «Count up Timer» displays your actual
brushing time. The «Count down Timer»
indicates the remaining brushing time. Starting
with «2:00» minutes, it goes down to «0:00».
When brushing longer than two minutes, it
automatically changes to the «Count up Timer».
The total brushing time can be extended to
3 minutes by using the «Extended Clean» mode
(see «Brushing modes» for more details).
Your toothbrush comes with the «Professional
Timer» and the «Count up Timer» activated. If
you wish to change these settings, proceed as
follows:
• Press and hold the brushing mode button (c)
for 3 seconds until the SmartGuide display
unit (i) shows «:30» and «timer».
3 sec.
3 sec.
• By briefly pressing the on/off button (b), switch
to the «2-Minute Timer». Confirm your choice
by pushing the mode button (c).
• This will lead you directly to the «Count up
Timer» display («up» and «timer» will be
shown). Switch to the «Count down Timer» by
pressing the on/off button and confirm it with
the mode button.
• To leave the setup menu press the mode
button again. The setup mode will be ended
automatically if no button is pressed for
60 seconds. Please note that all 3 pilot lights
are flashing while being in the setup menu.
14
SmartGuide display unit
Displayed
Meaning
Icon
«Daily Clean» mode
«Sensitiv» mode
«Massage» mode
«Polish» mode
«Extended Clean» mode
«Quadrant circle» – currently you
are brushing in the first 30-second
interval (45-second interval within
Extended Clean mode). Move to
the next quadrant of your mouth,
when the second segment starts
flashing.
Dentist recommended 2-minute
brushing time (3-minute brushing
time within the Extended Clean
mode) has been reached.
The rechargeable battery of the
handle is low. Charge the
toothbrush handle.
Batteries of the SmartGuide
display unit are low. Change
batteries of the SmartGuide
display unit.
Wall mount
If you prefer to mount the SmartGuide display
unit on a wall, mirror or other surface, use the
adhesive tape (k) to fix the wall mount (j). Before
doing so, make sure the chosen surface is clean
and dry (remove grease and dust first). Position
the wall mount so, that the Oral-B logo is
readable. Then, press the wall mount evenly and
firmly to the wall. Wait 24h before sliding the
