Immediately
prepare
your
riding
mower
for
storage
at the end of the season
or if the
riding
mower
will not be used
for 30 days
or more.
4_I, WARNING:
Neverstorethe
riding mower
with gasoline
in the tank
inside
a building
where
fumes
may reach
an open flame
or
spark.
Allow the engineto
cool before storing
in any enclosure.
MOWER
Remove
deck from
mower
for winter
stor-
age.
When
mower
is to be stored
for a
period
of time,
clean
it thoroughly,
remove
all dirt, grease,
leaves,
etc.
Store in a clean,
dry area.
1.
Clean entire riding mower
(See "CLEAN-
ING" in the Maintenance
section
of this
manual).
2.
Inspect
and
replace
belt,
if necessary
(See belt replacement
instructions
in the
Service
and Adjustments
section
of this
manual).
3.
Lubricate
as shown
in the Maintenance
section
of this manual.
4.
Be sure that all nuts,
bolts
and screws
are securely
fastened.
Inspect
moving
parts for damage,
breakage
and wear.
Replace
if necessary.
5.
Touch
up
all rusted
or chipped
paint
surfaces;
sand lightly
before
painting.
BATTERY
o
o
Fully charge
the battery
for storage.
If battery
is removed
from
riding
mower
for storage,
do not store
battery
directly
on concrete
or damp
surfaces.
ENGINE
FUEL SYSTEM
IMPORTANT:
It is important
to prevent
gum deposits from forming in essential fue!
system parts such as carburetor, fuel hose,
ortank during storage. Also, alcohol blended
fuels
(called gasohol
or using ethanol or
methanol) can attract moisture which leads
to separation
and formation of acids during
storage.
Acidic gas can damage
the fuel
system of an engine while in storage.
• Empty the fuel tank by starting
the engine
and letting
it run until
the fuel
lines
and
carburetor
are empty.
• Never
use engine
or carburetor
cleaner
products
in the fuel
tank
or permanent
damage
may occur.
• Use fresh fue! next season.
NOTE:
Fuel stabilizer
is an acceptable
al-
ternative
in minimizing
the formation
of fuel
gum deposits
during
storage.
Add stabilizer
to gasoline
in fuel tank or storage
container.
Always
followthe
mix ratio found on stabilizer
container.
Run engine
at least
10 minutes
after adding stabilizer
to allow the stabilizer
to
reach the carburetor.
Do not empty the gas
tank
and carburetor
if using
fuel
stabilizer.
ENGINE
OIL
Drain
oil (with
engine
warm)
and
replace
with clean engine
oil.
(See "ENGINE"
in the
Maintenance
section
of this manual).
CYLINDER(S)
1.
Remove
spark
plug(s).
2.
Pour one ounce
of oil through
spark plug
hole(s)
into cylinder(s).
3.
Turn ignition
key to "START"
position
for
a few seconds
to distribute
oil.
4.
Replace
with new spark
plug(s).
OTHER
IMPORTANT:
while
engine
• Do not store gasoline
from one season
to
another.
• Replace your gasoline
can if your can starts
to rust.
Rust and/or
dirt in your gasoline
will cause
problems.
• If possible,
store your riding mower indoors
and cover
it to give
protection
from
dust
and dirt.
• Cover
your
riding
mower
with a suitable
protective
cover that does not retain mois-
ture.
Do not use plastic.
Plastic
cannot
breathe
which allows condensation
to form
and will cause
your riding
mower
to rust.
Never
cover
riding
mower
and
exhaust
areas
are still
warm.
24