Idiomas disponibles
Idiomas disponibles
Become familiar with these terms
before operating the unit.
CFM:
Cubic feet per minute.
SCFM:
Standard cubic feet per
minute; a unit of measure of air
delivery.
PSlG: Pounds per square inch
gauge; a unit of measure of pressure.
Code Certification:
Products that
bear one or more of the following
marks: UL, CUL, ETL, CETL, have
been evaluated by OSHA certified
independent
safety laboratories and
meet the applicable Underwriters
Laboratories
Standards for Safety.
Cut-In Pressure:
While the motor is
off, air tank pressure drops as you
continue to use your accessory.
When the tank pressure drops to a
certain low level the motor will restart
automatically.
The low pressure at
which the motor automatically
restarts is called "cut-in" pressure.
Cut-Out Pressure: When an air
compressor
is turned on and begins
to run, air pressure in the air tank
begins to build. It builds to a certain
high pressure before the motor
automatically
shuts off, protecting
your air tank from pressure higher
than its capacity.
The high pressure
at which the motor shuts off is called
"cut-out"
pressure.
Branch Circuit: Circuit carrying
electricity from electrical panel to
outlet.
This unit is capable of powering the following Accessories.
The accessories
are
available through the current Power and Hand Tool Catalog or full-line Sears
stores.
Accessories
•
In Line Filter
• Tire Air Chuck
• Quick Connector Sets (various
sizes)
• Air Pressure Regulators
• Oil Fog Lubricators
• Air Hose: 1/4", 3/8" or 1/2" I.D. in
various lengths
Refer to the selection chart located
on the unit to select the tools this unit
is capable of powering.
ml_Tujj_[e,_
q=1
This air compressor pump is capable
of running continuously.
However, to
prolong the life of your air
compressor, it is recommended
that a
50%-75%
average duty cycle be
maintained;
that is, the air
compressor
pump should not run
more than 30-45 minutes in any given
hour.
9-ENG
D27312
