Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
3. Using a stud finder or equivalent tool, locate at
least 1 wall stud and mark its positions on the
wall. While holding the support bar in its position
against the wall, check that it is level, then mark
3 positions for 3 holes as indicated. One of the
holes must be right over the wall stud.
4. Keep the support bar in the position, then drill
pilot holes on the wall through the support bar at
the marked positions using ø1/8" (2.5mm) drill bit
as illustrated.
5. Except for the hole that is over the stud, drill in
the existing holes on the wall using ø5/16" (8mm)
drill bit and insert the wall anchors (AA) into the
holes using a rubber mallet until the wall anchors
are flush with the wall.
Hardware Used
ø8 x 40 mm
AA
Wall Anchor
3
4
5
x 2
7
ø1/8"
2.5mm
ø5/16"
8mm
AA
