Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
6. Replace and secure the support bar with screws
(BB).
Hardware Used
ST8 x 60 mm
BB
Screw
7. Gently hang the cabinet on the support bar.
8. Open the door, measure and mark two holes,
one of the holes must be right over the wall studs
(previously identified) respectively from the back
of the cabinet. Make sure the two holes avoid
the existing screws behind the cabinet at the
indicated locations as shown below. The cabinet
could be moved horizontally before it is secured,
so If the existing screws happen to be located
over the studs, move the cabinet left or right a bit
to avoid the existing screws overlap with the two
holes to be drilled.
6
x 3
7
8
4 3/4"
120mm
8
12"
4 3/4"
12"
305mm
120mm
305mm
BB
4 3/4"
120mm
