Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
1. Place the tip-over restraint (DD) on the wall at
a proper height, mark the positions of the holes
onto the wall.
WARNING: Customer must install the tip-over
restraints provided.
Serious or fatal crushing injuries can occur from
furniture tip-over.
Use of tip-over restraints may only reduce, but not
eliminate, the risk of tip-over.
Hardware Used
DD
Tip-over restraint
2. Gypsum wallboard or concrete walls: Drill pilot
holes in the marked locations with a ø 5/16" (8
mm) drill bit. Insert the wall anchors (AA) using
a rubber mallet until the wall anchors are flush
with the wall.
Solid wood walls: Drill pilot holes in the marked
locations with a ø 1/16" (2 mm) drill bit. Wall
anchors are not necessary.
Hardware Used
ø9 x 30 mm
AA
Wall Anchor
3. Install the tip-over restraint onto the wall with
screws (BB).
Hardware Used
ST4 x 32 mm
BB
Screw
DD
Tip-over restraint
1
x 1
2
x 2
3
x 2
x 1
7
DD
AA
ø5/16"
8mm
DD
BB
