Idiomas disponibles
Idiomas disponibles
E
N
G
L
|
S
H
20
Installation Guide continued
Motor Antenna
Connect the vehicle motor antenna
lead to the
blue motor antenna relay control lead.
Battery
Connect the yellow battery lead to the correct
radio wire or to the battery fuse port on the fuse
block.
Antenna
Connect the antenna by plugging the antenna lead
into the antenna receptacle.
Equipment
Connect any optional equipment such as amplifier,
according to the instructions furnished with the
equipment. Keep about 12 inches (30 cm) of
distance between the speaker cords/amplifier unit
and the antenna/antenna extension cord. Read
the operating and installation instructions for any
equipment you will connect to this unit.
Power
Connect the red power lead to the correct vehicle
radio wire or to the appropriate fuse port on the
fuse block.
If the stereo unit functions properly with all these
connections made, disconnect the wires and
proceed to the final installation.
Q Installation Procedures
1. Secure the Mounting Collar @.
U Final Installation
Lead Connections
Connect
all wires,
making
sure
that each
connection is insulated and secure. Bundle all
loose wires and fasten them with tape so they
won't fall down later. Now insert the stereo unit
into the mounting collar.
Congratulations!
After making a few final checks,
you're ready to enjoy your new auto stereo
system.
A Final Checks
1. Make sure that all wires are properly
connected and insulated.
2. Make sure that the stereo unit is securely
held in the mounting collar.
3. Turn on the ignition to check the unit for
proper operation.
lf you have difficulties, consult your nearest
authorized professional installer for assistance.
Insert Mounting Collar @ into the car's dashboard, and bend mounting tabs out with a screwdriver.
Dashboard
(D Mounting Collar
CQ-R155SEUC
Mounting Tab
Screwdriver
