Idiomas disponibles
Idiomas disponibles
Align the screw (14) with the corresponding hole in the rear
grille and tighten it.
Align the front grille (1) with the rear grille (4) and press
firmly to adjust. Close all clips and tighten the locking screw
if it has come loose.
The remote control (10) has 1 CR2025 battery. Remove the
back cover of the remote control and insert the batteries,
taking into account the correct polarity.
INSTALLATION
Before installation, select a suitable
location for the fan where it cannot
cause an obstruction.
Draw an horizontal line apart to
mark the right and left screw holes
for the bracket.
On the like mark 2 hole 165mm
either side of the center line.
Drill holes at the points marked
with a 6 mm drill bit (¼") and insert
a wall plug.
Attach the bracket to the wall and
fully tighten all screws.
Slide the fan over the bracket, then
insert and tighten the wing screw in
the hole at the top of the switch
cover (9) to hold it in place.
4. USING YOUR APPLIANCE
NOTE: Before inserting the plug into an electrical outlet,
make sure that the voltage corresponds to that indicated on
the product label, and that the plug has a ground connection.
19
