Idiomas disponibles
Idiomas disponibles
CLEANING AND MAINTENANCE
See
picture 09 on page 6.
• After each use and once the oven has
cooled down, clean it with a slightly
damp cloth.
• Before cleaning, unplug the oven or
turn it off with the on/off knob.
• Wait for the oven to cool down before
cleaning it.
• Use stainless steel cleaners to clean
oven surfaces made of this material.
• Make sure cleaning products do not
contain particles that can scratch
enamel or painted surfaces.
• When cleaning the oven door and
glass, do not use any materials that
may damage the surface such as
abrasive cleaners, metal scrapers or
bleach.
• Do not use steam cleaners.
• Do not use strong abrasive cleaners or
sharp metal scrapers to clean the glass
door, as they may scratch the surface,
which can lead to glass breakage.
• Do not use abrasive or acidic cleaning
products on any part of the oven, as
this could damage the appliance and
cause stains.
• To clean the internal and external
glass of the oven, use sponges or damp
rags.
• For an in-depth cleaning, the internal
glass of the oven can be removed from
the body. To do this:
• Open the door.
• Open the hinge case clips on the right
and left sides of the front door by
pressing them down.
Open the main door halfway
• Remove the front door by pulling it up
to free it from the right and left hinges.
• To reinstall the door, you must follow the
same steps in reverse order. Remember
to close the hinge housing clips when
reinstalling the door.
To remove the inner glass of the door
picture 10 on page 6)
• While the door is open, slide the glass
into the oven until it is free of the lower
tabs. Wash and dry the glass.
• Follow these steps in reverse order to
replace the glass in the oven door.
Oven seal (see picture 11 on page 6)
The oven seal can become dirty over
time. In this case, you can clean it with a
damp cloth. Never use strong or abrasive
cleaning agents for this procedure. If the
seal is worn or torn, please contact the
supplier of the appliance.
Side rails (see picture 12 on page 7)
Side rails can be easily removed. You have
to stretch the tab, which is attached to the
screw, downwards to remove the rails.
*Note: not all the oven models have this
rail system.
Oven light
Before replacing the oven bulb, make sure
the product is completely turned off and
disconnected from the electricity.
The oven bulb must have the following
specifications:
•
Heat resistance up to 300ºC,
•
Power values: 220-240V ~ 50Hz,
•
Power: 15 W
The light bulb inside the oven should be
replaced as shown in picture 13 on page 7.
• Turn the outer glass of the body
counterclockwise to remove it.
•
Remove
counterclockwise or pulling it towards
you.
•
Insert the new light bulb.
•
Reinstall the outer glass
PROBLEM RESOLUTIONS
• The oven emits smoke when in use:
It'ss normal that some smoke comes
out during operation, this is not a fault.
• The oven emits metallic sounds when
it'ss heating and cooling: When metal
(See
parts get hot, they can expand and
cause noise. This is not a fault.
the
bulb
by
turning
EN
(A)
it
29
