Idiomas disponibles
Idiomas disponibles
Charging the battery pack
NOTE
:
The batteries are shipped uncharged.
•
Each battery must be fully charged
before the first use.
•
Always fully charge the two batteries
at same time. More details can be
found in charger's manual
WARNING! The charger and battery
pack are specially designed to work
together, so do not attempt to use any
other devices. Never insert or allow
metallic objects into your charger or
battery pack connections because of an
electrical failure and hazard will occur
Checking the battery condition
NOTE
Fig. A2 only applies for the
:
battery pack with battery indicator light
Installing & removing the battery pack
NOTE
:
This machine will only run when 2
•
batteries are installed. It is recom-
mended to use the same two batter-
ies and charge the two batteries at
the same time.
When you use two batteries with
•
different power,the machine will
only run to the level of the lowest
charged battery
.
ASSEMBLY
Concentrator nozzle Installation
OPERATION
Starting & Stopping
The tool runs for a few
WARNING!
seconds after it has been
switched off.
Let the motor come to a complete stand-
still before setting the tool down.
40V Cordless Blower
.
See Fig.
A1
.
See Fig.
A2
.
See Fig.
B, C
See
Fig. D
See
Fig. E
Adjusting the blowing speed / air volume
with 3-speed switch
USER TIPS
-
Hold the blower tube approximately
8" above the ground when operating
the tool.Use a sweeping motion from
side to side.
-
After blowing the debris/leaves into a
pile, it is easy to dispose of the pile.
Caution!
- Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near
bystanders or pets.
- Use extra care when cleaning debris
from stairs or other tight areas.
- Wear safety goggles or other suit-
able eye protection, long pants, and
shoes.
Turbo button for power boosting
NOTE:
•
Turbo button for power boosting can
increase air flow significantly, and it
can be used for clearing heavy or wet
debris.
•
First switch on the blower and select
a speed control (speed I, II or III),
then depress the turbo button and
hold it.
Release the Turbo button, the blower will
return to the previously selected speed.
FOR BATTERY TOOLS
The ambient temperature range for the use and stor-
age of tool and battery is 0
The recommended ambient temperature range for
the charging system during charging is 0
(32
F-104
F).
o
o
5. CLEANING THE TOOL
Clean the tool regularly.
WARNING! Keep your product dry. Under no
circumstances spray with water.
-
To clean the tool, use only mild soap and a damp
cloth.
-
Do not use any type of detergent, cleaner or
solvent which may contain chemicals that could
seriously damage the plastic.
-
Self lubricating bearings are used in your
product, therefore lubrication is not required.
See
Fig. F
See Fig.
G
C-45
C (32
F-113
F).
o
o
o
o
C-40
C
o
o
EN
13
